Electronics Forum | Wed Oct 10 13:13:44 EDT 2007 | jsloot
Any body using any kind of special finger marker stickers used to check wave solder conveyor fingers parellism? If so please contact me.
Electronics Forum | Tue Jul 18 10:16:49 EDT 2006 | russ
Clean up!, check all conveyors for paste, the printer, oven. If you are splattering in the oven than you need a better profile or better paste, one of the two, maybe both. Hope was helpful Russ
Electronics Forum | Tue Jul 18 19:20:25 EDT 2006 | sharifudin
Actually we run lead free solder paste and the profile spec very tigh.I can't use capton tape due my product in panel form and save cost.I already verify conveyor,machine and tool free from dust and solder paste but the problem still remain.
Electronics Forum | Mon Feb 05 20:43:27 EST 2001 | davef
1 Solder on gold fingers comes from: 1a About 70 % of the time it's caused by poor cleaning of screen printer, staging area (table), conveyor, reflow oven chain or belt, and keeping boards separate from cleaning process 1b After loading paste onto
Electronics Forum | Sun Oct 30 06:13:23 EST 2005 | mika
I am sorry for my poor english, but perhaps you will undertsand:-) The important thing is to get the conveyors straight: The front fixed rail must be parallel with the next one and also the heigt. The heihgt of the prior conveyour should be (but not
Electronics Forum | Fri Jan 25 16:07:07 EST 2002 | davef
On your coating ... * What is the material coating? * What is the purpose of the coating? So, is this coating something that was on the fingers on your conveyor and is now transmigrating to your boards? We replace 20 of our titanium fingers on our
Electronics Forum | Mon Dec 12 22:14:42 EST 2005 | davef
�a va Frank? Well, popularity depends on the beholder. Never heard of your "Specnor" machine. US and Eurolanders take different approaches to conveying boards. * US: Finger conveyors * Eurolanders: Pallet conveyors Suppliers of wave solder machin
Electronics Forum | Fri May 02 11:09:13 EDT 2014 | pawloa
Hello. We have a Minipak 300 wave solder machine from Electrovert and are looking in particular for a tachometer that attaches on the finger conveyor motor to measure the speed in pulses. We are also looking for the thermocouple that is used to moni
Electronics Forum | Tue Aug 13 17:03:37 EDT 2002 | Mick
The Electra and Electra 500 are basically the same. 20 or 24" As far as the other items Spray fluxer type can be picky on flux type(solids content etc)and also there are choices for selective spraying Check out finger conveyor config - may suit palle
Electronics Forum | Fri Jul 14 11:34:37 EDT 2000 | Mike F
John, The first thing to check is how tight the boards are being held in the conveyor (assuming you are using a finger conveyor). They should be a little loose at the input end so there is some room to expand. If the boards are held too tightly, when
