Electronics Forum | Wed Jan 02 12:03:13 EST 2019 | jdengler
They go through TN-3 to get to the TSA-200A D/A module. This is all in the MTU. It's been a long time since I worked on an IP-2 but see if you can get to the I/O screen for the MTU. Have someone flag the in range sensor and see if the input status on
Electronics Forum | Fri Dec 21 09:40:40 EST 2018 | kdexter0928
I am at wits end with this machine. The MTU on my IP2 will not zero set. It gives me a few different errors depending on its mood. I receive MTU T- OT, MTU X- OT, or MTU Y- OT. when the machine attempts to zero set it travels until it OTs. I have tri
Electronics Forum | Wed Jan 02 10:20:10 EST 2019 | jdengler
Sorry, I looked at an IP-3 not 2. It looks like for the IP2 they bundle the MTU and machine proper together so it should be sending the data when you transmit the one file. Do the axis travel in the correct direction? If yes the only thing I can
Electronics Forum | Fri Aug 19 08:00:13 EDT 2016 | eplankey
I’ve been tasked with acquiring both pricing and specification information on potential X-Ray units. If possible I would like to gather information on both low-end and high-end units. Here is some information on our facility. I have been to facili
Electronics Forum | Tue May 28 11:36:46 EDT 2002 | floydl
Hello Jim, Is any special tooling required for press-fitting a connector?
Electronics Forum | Tue Dec 14 20:31:53 EST 2004 | davef
The FIT we mentioned is for a stocked, finished good item. It's for something shipped to a customer.
Electronics Forum | Tue Aug 24 20:12:12 EDT 2010 | davef
What is a "SMD push fit connector?"
Electronics Forum | Thu Oct 21 19:18:05 EDT 2021 | rwyman
Or, it may not fit where it's supposed to fit. That would not make for a happy customer!
Electronics Forum | Tue Dec 14 10:58:56 EST 2004 | Peppe
Thanks for your answer Dave. Just a clarification. Given FIT is for just one soldering or for a specific number ? I mean cards we produce have, typically, 10000 soldering joints. Which is the expected FIT of that card ? Thanks again for your help.
Electronics Forum | Mon Jan 22 03:51:16 EST 2007 | Bing
We are using HASL board for Press Fit, without problem in the past until recently. Now we are seeing the solder in the PTH melt and block partially the PTH hole during the reflow. It gives problem when Press Fit. Anyone has advice on this?