Electronics Forum | Fri Oct 11 13:47:48 EDT 2002 | mnaddra
Does anyone know of automated equipment makes and models for auto inserting press fit connectors in to backplanes. Mike
Electronics Forum | Tue Nov 05 00:53:31 EST 2002 | YNgwie
How do we do press fit component rework ? I have connectors with 700 pins, and the rework part is a headache. What is the best method ? Thanks in advance.
Electronics Forum | Thu Sep 11 21:41:16 EDT 2003 | raf
I need to know if MV2F K type feeders fit on a MV2VB K type machine. thank you in advance, Raf
Electronics Forum | Tue Dec 14 08:32:10 EST 2004 | davef
Depending on the design, materials selection, end use, etc; we'd expect the FIT of an electronic assembly to be between 30 and 100+. There is no standard.
Electronics Forum | Sun Apr 03 00:16:56 EST 2005 | Haran
Can anyone advise how to determine the right hole diameter for a Press Fit connector's lead based on the lead compliant section?
Electronics Forum | Wed Aug 31 15:25:05 EDT 2005 | lyrtech
Hi, Does anyone knoews a place where i can find a used presse to place press-fit connector? Only a couple of company are distributing this item. I want a used one for cost reason. Regards
Electronics Forum | Thu Apr 10 16:02:04 EDT 2008 | brulal1
Hi,we are looking to use Press fit connector on our PCB assemblies. Did anyone out there have any issue with press fit connector? Thank Bruno
Electronics Forum | Tue Aug 17 04:43:57 EDT 2010 | aj
Hi all, Just looking for some advice on SMD push fit connectors. Are most machines spec'd do place these reliably or do they cause problems? AJ...
Electronics Forum | Thu Aug 23 17:55:44 EDT 2012 | spitkis2
You need a fitting (brass or stainless steel. As mentioned above, McMaster Carr is one source. Look here http://www.mcmaster.com/#miniature-brass-barbed-tube-fittings/=iz8t1h You will need to know the thread.
Electronics Forum | Wed Oct 15 03:59:00 EDT 2014 | rob
Are you using specific tooling for each part, or just generic? If so it could be pushing down at an angle and slightly tearing the PCB. We use the same style press as you but make custom fixtures to fit each connector and hold each PCB tight.