Electronics Forum | Mon Sep 27 22:12:18 EDT 2004 | KEN
Ahmen Brother Russ. Lets fix the trade imbalance.
Electronics Forum | Mon Jan 23 08:06:52 EST 2017 | bukas
i have an issue with solder bath temperature. there is a big difference in temperature of alloy in the middle of the bath and at the ends(about 35C). i took down heating elements for inspection and they look fine. its just that most of the heat is cr
Electronics Forum | Fri May 06 10:46:09 EDT 2005 | peterdroy
I have created a zevatech users group to help all of us using these machines, for tweaks and fixes or just locating buying trading selling parts and feeders etc Pete Send emails to the group at zevatech@yahoogroups.ca
Electronics Forum | Fri Jun 06 17:47:14 EDT 2014 | hegemon
SWAG has it. Carriers for SMT are a great idea, especially to mitigate sag, and allow some savings in setup. Fixturing setup advantage: You could fixture everything to a fixed width, and eliminate rail setups throughout your lines. Trade off the f
Electronics Forum | Mon Aug 25 08:26:33 EDT 2008 | scottp
We've gone through this a couple times. Once it was because the device was warping in reflow. We confirmed with shadow moire that the corners were lifting up. The supplier fixed some things in their molding process to reduce the warpage. Another
Electronics Forum | Sat Aug 22 01:56:54 EDT 1998 | Lance A. Smalley
Panapro Host Optimization should actually be very good. Make sure you're not using a fixed setup or the feeder carriage will move alot. Also make sure you do not change parts data in the machine after the program has been generated or speed of the
Electronics Forum | Fri Mar 06 10:50:21 EST 2009 | fountain42
Just my opinion but it look's like your doing a great job. i would try another paste. I'm somewhat lucky that we get to use OA's. If your stuck using the no-cleans they are so tempermental. (The nitrogen is making up for the poor paste) Your de-wetti
Electronics Forum | Thu Jan 31 15:58:27 EST 2013 | larrygroves
David, Its real hard to find a quality machine for 20K. Keep in mind that a machine with many years on it will need parts at some point and it can cost a lot to fix them. My advice for what its worth is: 1.check with the companys selling new eq
Electronics Forum | Tue Jan 11 09:47:01 EST 2000 | Dave F
Abbas: Sources of information on DFM/DFT are: � "SMTnet Express" articles on DFM by Earl Moon � IPC-D-279, 'Design Guidelines for Reliable Surface Mount Technology Printed Board Assemblies' � Books in SMTnet and SMTA book stores � Other examples ar
| 1 |
.gif)
