Electronics Forum | Fri Sep 21 10:35:37 EDT 2012 | davef
Flash gold is just thin electrolytic gold plating over electroless nickel or electrolytic nickel. Flash gold plating ... * Less than 3 microinch thick will be porous and take solder poorly * Greater than 10 microinch thick will cause brittle solder c
Electronics Forum | Tue Feb 01 06:54:19 EST 2000 | Roni H.
Hi, Does anyone have experience with gold over nickel (electroless) PCB finish: - Repeatble quality from PCB mfg. (very "painfull" with ENTEK). - Environment condition sensitivity. - Thermal processes sensitivity. - Solderability (Reflow & wave). -
Electronics Forum | Mon Apr 28 09:59:04 EDT 2003 | davef
Your customer's question is reasonable. Soldering to nickel is not always a walk on the beach [can of corn, or whatever]. This issue is flux not solder. Your Sn63 will have plenty of strength, providing the solder connection is well formed. You s
Electronics Forum | Mon Sep 24 10:07:46 EDT 2012 | eezday
The answer, as stated above, is 3 microinch's however, it is equaly important, if not more important, to understand that the only function of the gold is to protect the surfaces beneath it. Only enough gold to cover the nickel beneath it should be u
Electronics Forum | Tue Feb 01 09:53:58 EST 2000 | Ron Costa
I've been using the Electroless Nickel/Immersion Gold plating process for some time now. Here is what i know: It's very flat and solderable if you hold the board house to the following criteria: 120u inches of Nickel 4-9u inches of Gold What type of
Electronics Forum | Tue Feb 01 21:51:05 EST 2000 | Dave F
Roni: Ron gives good advice on the thickness of your Electroless Nickel - Immersion Gold (ENIG) solderability preservative. Several additional comments are ENIG: � More expensive than OSPs and HASL. � Much flatter surface than HASL, similar to OSP
Electronics Forum | Wed Dec 28 16:03:53 EST 2005 | Chris
I have lots of experience with thermosonic gold ball bonding. You can read the literature and you will probably find some papers that say you can do it. I have never been able to do it. We gold ball bond all day long with little problems at all bu
Electronics Forum | Mon Oct 27 20:01:00 EDT 2014 | rangarajd
Hello, We are facing solderability issues on a particular lot of board. THe Nickel thickness measured with an XRF is around 400 U inches. Spec calls out for 130 u inches Nickel and 3 - 5 U inches gold over it. Assuming there is no porosity on the g
Electronics Forum | Tue Aug 20 18:15:02 EDT 2002 | davef
Haaaaa!!!! Soldering to plastic!!!! An apt analogy!!! I like to compare it to soldering to dirt. Some thing. In fact, you are soldering on nickel, when soldering on many things. It�s just that the gold, er Pd, flash enables the wetting mechanism
Electronics Forum | Wed Aug 11 18:36:03 EDT 2004 | davef
90 Knoop. Q2: Thickness is 4 to 10 u" for Au and 300 to 400 u" for nickel A2: This looks like a ENIG spec. Although, the Ni is quite heavy, 150 uin is sufficient for most applications. [IPC-4552 ENIG specification: * Gold thickness of 0.075 - 0.125
winsouce.jpg)