Electronics Forum | Fri Dec 30 05:53:32 EST 2005 | JOE
magazine unloader, flat belt conveyor, or a box with some foam inside of it.
Electronics Forum | Tue Apr 25 13:05:08 EDT 2006 | Hoss
TMC, Are you interested in this approach because you only have a flat belt conveyor and want to keep the components from being moved by the belt on the second pass? If so, you might try adding some stiffeners to the board edges to stand the board o
Electronics Forum | Fri Oct 07 14:59:07 EDT 2005 | gregcr
Hi Jimmy, We use flat belt exit conveyors. They are set-up to collect the boards and set off an alarm when the belt is full. This allows the boards to come out, but you don't have to pay someone to stand there and catch each board. Also eliminate
Electronics Forum | Mon Mar 26 09:41:03 EDT 2018 | fuji_user_2014
Hi Gurus, Looking for alternatives to line makeup after reflow oven. Currently, I have a continuous on flat belt conveying out of my reflow oven straight to an EOL bench. The operator manually picks up the board off the belt (there is a roller at t
Electronics Forum | Tue Sep 14 17:49:36 EDT 2010 | g2garyg2
The problem with the Sunsda units is that they use a special circuit board, not PLC and Chinese software for programming, so getting into the program to find out what is going on is a problem. Have you replaced the SMEMA cable? I have seen bad ones.
Electronics Forum | Fri Jul 24 12:02:06 EDT 1998 | Steve Gregory
Stoney, One thing you might do before you start dispensing epoxy, (...I know this might be a bit of a pain) is to run your boards on the mesh belt instead of the edge-rail conveyer. I used to have to do that with some very,very dense double sided mem
Electronics Forum | Fri Apr 08 17:23:34 EDT 2005 | KEN
Warpage factors can cause: 1. Boards can not transfer down conveyor belts or wedge at transitions. 2. May not enter into machinery due to interferences (like board clamps) 3. May fall off conveyor chain in furnace. Especially true of thin (PCMCI
Electronics Forum | Mon Mar 26 16:58:53 EDT 2018 | solderingpro
Is there anything stopping you from replacing the flat belt solution to a continuous running steel roller chain conveyor? - From there (depending upon board temperature) you should be able to buffer your boards in a vertical buffer station if neede
Electronics Forum | Tue Jun 17 15:52:51 EDT 2003 | russ
Is this a single sided or double sided board? We run the first side flat on the oven belt this keeps the board flat for the second side assembly. If the board warps during the second reflow process we will make a support fixture to carry the PCBA
Electronics Forum | Mon Aug 27 11:11:16 EDT 2012 | rway
We have 1/2 dozens 0.031 pcbs that bow after going through the oven. We are looking for a solution to this problem to prevent bowing of the pcbs. As a result of the bowing, the pcbs, on occasion get caught in the oven, and more often have transfer
winsouce.jpg)
