Electronics Forum | Wed Jan 05 07:06:43 EST 2000 | Christopher Lampron
Chiakl, Advanced Circuit Technology in Nashua, NH manufactures low cost polyester flex in a reel to reel process. They can be reached at (603)880-6000. Hope this helps Chris
Electronics Forum | Tue Jul 15 15:36:31 EDT 2003 | chad
Mike, I'd be more then happy to talk with you offline about pallets for flex assemblies. We have lots of experience with the manufacturing issues associated with them. Thanks, Chad Haima Pentagon EMS 503-924-2747 chadh@pentagon-ems.com
Electronics Forum | Wed Apr 23 08:38:36 EDT 2003 | davef
You'd like to think the epoxy holding you pallet together will cure sooner, rather than later, wouldn't you? Sounds strange to us.
Electronics Forum | Wed Apr 23 13:27:29 EDT 2003 | chad
What's the actual brand name of the material? I could give you our experiences with most brand types both from a manufacturing and customer standpoint. Thanks, Chad Haima Pentagon EMS chadh@pentagon-ems.com 503-924-2747
Electronics Forum | Wed Jul 01 13:57:07 EDT 2015 | circleprime
I have a customer that is requesting their flex circuit be conformally coated. Is this something that is done? Which coating would stand up to the stresses of flexing? Wouldn't that put stress on the components? Thanks! Shannon
Electronics Forum | Tue Sep 08 16:32:23 EDT 2015 | duso02
Commonly done with Parylene.
Electronics Forum | Tue Jul 15 10:36:33 EDT 2003 | davef
Equipment, Sldr pallet * Garland Service Company (972)494-1911 fax 0972 http://www.goGSC.com * Datum Dynamics 207 Highpoint Avenue Portsmouth, RI 02871 401-683-5300 FAX 3995 http://www.datumdynamics.com * EES/Grip Technogies Weston CT 203/226
Electronics Forum | Wed Dec 22 18:09:07 EST 2004 | kmorris
At a previous job I had been taught that when reflow soldering polyimide flex circuits, it was necessary to pre-bake them before reflow soldering to prevent delamination. Our procedures said that there must be a 1hr bake prior to reflow, and the flex
Electronics Forum | Fri Jul 24 16:39:16 EDT 2015 | cnotebaert
have done it in the past, used silicon as it will flex,, however its not the most robust material! tends to peel/flake off.
Electronics Forum | Wed Jul 29 11:28:54 EDT 2015 | pankyb1261
How many times does it have to flex. There are acrylic conformal coatings that can be bent once to 90 degrees or so
Midwest Circuit Technology provides Carbide Router Bits and End Milling Cuters for use in PCB Depaneling equipment. We have over 35 years of supplying tools and machining experience in drilling, Routing, Test Fixture manufacture.
114 Barrington Town Square
Aurora, OH USA
Phone: 13309956900