Electronics Forum | Thu Feb 27 15:14:53 EST 2020 | SMTA-Alex
This happens with either old tape, the cover tape doesn't stay sealed on the left side, or is the seal is too far to the right, the knife lifts the cover tape. There isn't much you can do in this case. Your choices are: switch the component into an A
Electronics Forum | Thu Jul 02 08:27:46 EDT 2015 | sssvajunas
Maybe someone know where company can buy MYDATA FLEX 24mm feeders(only used)? Becouse I found only Flex magazines, 32mm, 44mm feeders but not 24mm.
Electronics Forum | Tue Apr 25 22:18:59 EDT 2023 | spoiltforchoice
Because I guess for almost years nobody else even came close to having an overlapping sales pitch. However, today, most brands have a "flex" placer, feeders that can take strips of tape and software options that help in some way with running smaller
Electronics Forum | Wed Sep 30 08:29:15 EDT 2015 | johanbergstrom
The difference between TMC Flex and TMD Flex is about the ability to feed component tape with deep pockets for larger components. The TMC have a rather low passage for embossed component tape. While TMC Flex is limited to a maximum tape depth of 7,5
Electronics Forum | Fri May 14 08:30:52 EDT 2004 | pjc
For any application- high-mix, low volume to low-mix high-volume: J.O.T. Automation board handling MPM UltraFlex 3000 printer CyberOptics SE300 3D post print inspector 2x Mydata Synergy II w/ Linear Magazines and Agilis feeders CyberOptics Flex
Electronics Forum | Fri Feb 02 14:56:57 EST 2007 | Wagoner
Mimot is another machine that is well suited for prototype runs. It's slower than a chip shooter and it is really a flex placer. You can keep a lot of fixed feeders and it is pretty easy to set up. Operator interface is excellent and programming i
Electronics Forum | Tue May 06 09:44:23 EDT 2003 | gregp
A quick question(s) to anyone who operates SMT lines with only one multi purpose flex machine (P&P). What is an ample feeder count for this machine?...and secondly, do you have a standard kit of common parts that you would wish to reside permanantly
Electronics Forum | Wed Sep 21 12:30:03 EDT 2005 | Rob
Hi Greg, We've used lots of machines over the years & seen lots of different tape related issues - the main one being snap off of the cover tape, usually due to too much glue, over entusiastic heat seal, or a feeder requiring maintainance. Also the
Electronics Forum | Fri Jan 13 09:48:27 EST 2017 | westshoredesign
10mins to print an 8mm wheel. Experimenting with both Ninja Flex, and Ninja Semi-Flex, I think the Flex is probably going to be the winner though. Had to upgrade our filament feeder on the printer to use either of them. Totally worth it though. Not s
Electronics Forum | Wed Jan 12 14:47:09 EST 2005 | gregp
This will always be the case with in-line spindle machines that rate their cph based on unreal conditions. Flexible placement machines with different head designs will perform better (closer to advertised) and are truley more flexible because you do
.gif)
winsouce.jpg)