Electronics Forum | Thu Jun 26 03:27:35 EDT 2003 | loz
We currently have a requirement to build flexi circuits and mount two 40 way, 20 thou connectors at each end. The flexi pcb's arrived in singlulated format. Ideally we would like to have the circuits panelised for machine building as hand placing the
Electronics Forum | Thu Jun 26 09:04:43 EDT 2003 | caldon
We had a "Spring loaded" fixture that pulled the Flex tight and used loads of Board supports. There were pins that went through the Connectors holes and held the flex firm. We only had a few components so it was no problem. Lucky for us because the f
Electronics Forum | Thu Jun 26 10:03:36 EDT 2003 | swagner
We have been processing a 3 and 5 up flex array for nearly four years on pallets and have had a pretty steep learning curve. Make sure you have vacuum holes in your pallet for the screen printing process, also work with your support block vendor to
Electronics Forum | Mon Jun 26 08:54:35 EDT 2006 | dougs
We have a new product in where a 0.7mm pitch uBGA is to be placed on a 2 layer flexi board. Also a 20thou pitch connector. Has anyone done anything like this before, what should i look out for. Not done much flexi work before so any tips will be g
Electronics Forum | Wed Apr 01 04:34:41 EST 1998 | Alan Pestell
We are looking at reflow soldering some Flexi-rigid pcbs. I have heard that IR reflow soldering can make the Polyimide "self heat" and cause de-lamination. Does anyone have any info.
Electronics Forum | Thu Jan 31 22:13:21 EST 2002 | Nell
Hi, Could anyone tell me what are the critical things need to take note while running the flexi circuits assembly. Any comments will be appreaciated. Thanks and Regards.
Electronics Forum | Tue Sep 17 04:32:05 EDT 2013 | leeg
Has anyone got any experience of cut-out / break out of PCBs that are flexi-rigid circuits? What tooling / companies are out there that provide solutions, preferably UK based companies.
Electronics Forum | Wed Feb 20 21:42:21 EST 2002 | Nell
Hi Scott, Thanks for your feedback. I will take note on that. Cheers, Nell
Electronics Forum | Tue Jul 11 11:18:06 EDT 2006 | dougs
Thats a good point SWAG, i'll look into that for the next run of these. cheers
Electronics Forum | Tue Jan 19 19:41:09 EST 2021 | rgduval
Double check your p/n and your datasheet, and with your supplier. I had this happen one time, though it wasn't with flexi-term parts. Mine ended up being palladium plated end-caps (my buyer and receivers had all missed the applicable suffix issue o
