Electronics Forum | Mon May 16 09:54:06 EDT 2011 | vickt
This could be the cause. A simple test is as follows: Turn on the clutch for the specific spindle in I/O and use your hand to rotate the z shaft to drive down the spindle. Drive the spindle by hand to the end of travel and try rotating beyond that
Electronics Forum | Sun Oct 11 21:19:51 EDT 2009 | fulldrawmike
we have both flexjet and flexhead, we also have the new inline 7 head on some genesis dual beams we just put into operation. If you have a choice in flexjet heads take the inline 7. The flexjet 09 head is very labor intensive, stay away from them, e
Electronics Forum | Thu May 12 16:23:00 EDT 2011 | vickt
Is this a consistent issue? Have you tried running in "step mode" to see if it's really a handling related issue (ie Clutch, bearings, etc)? Good Luck
Electronics Forum | Fri May 13 09:11:01 EDT 2011 | vickt
And does this problem spindle exchange nozzles in the changer without issues? When was the last time the clutches were replaced? thx
Electronics Forum | Fri May 13 17:58:14 EDT 2011 | jbaez1
Hi VicKt! I will check the spindle nozzle changer issue this weekend, and the clutches were replaced since long,long time ago....probably more than 2 years..could be this the cause? for only one spindle? Thanks....
Electronics Forum | Sun May 04 20:11:53 EDT 2008 | marcelll
I'm working on a regular base with Advantis. There's nothing special regarding maintenance with the machine itself, only standard greasing & cleaning each 3-4 months. An hour or two maximum. If you have lightning head on it, it's maintenance free. I
Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval
Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the
Electronics Forum | Wed Mar 19 19:19:41 EDT 2014 | dave222
thank you for taking the time to look at this post. hopefully someone can help. I have a GSM2 Q block with a Flexjet 7 spindle head. a couple of days ago the machine encounter this issue while zeroing. the issue is with head 2 on beam 2. on the di
Electronics Forum | Fri Jul 14 17:32:36 EDT 2023 | ttheis
Having an issue with changing nozzles on one of our FJ3 heads. We get errors on spindle 5 and 6 when bank-changing nozzles. Event code 31208, unable to find any info on this code. When we use the put nozzles away routine it does it no problem but has
| 1 |
winsouce.jpg)
.gif)
