Electronics Forum | Fri Jun 25 13:56:01 EDT 2010 | tate350
Consider using wavesolder pallets that keep the board flat during wave. Keep the board in the pallet after wave until it cools down a bit then remove it.
Electronics Forum | Tue Aug 10 03:42:04 EDT 2010 | aungthura
is it usual if the board has warpage on both sides after wave soldering? And, if it is, please advise me how to solve it. Thanks in advance.
Electronics Forum | Fri Jul 09 06:51:46 EDT 2010 | cobar
Try titanium edge stiffners on the PCB before making solder pallets.
Electronics Forum | Fri Jun 25 22:30:47 EDT 2010 | smthexi
i think you need to use a PCB central support. do you know that part ? it specializes in preventing PCB board from bowing during wave soldering.
Electronics Forum | Thu Jul 01 11:48:10 EDT 2010 | mb_mfg
Sid, Try baking the boards before running, to insure no moisture. Baking out the moisture will help prevent warping. Should you need further assistance, we supply fixtures to force the board to stay flat to reduce to thermo shock during wave solde
Electronics Forum | Thu Jun 24 15:33:56 EDT 2010 | davef
Our best suggestion - get the copper balanced and if possible go to higher Tg materials.
Electronics Forum | Fri Jan 28 05:06:01 EST 2000 | Istv�n Dominik
Hi! I have problems with the SMD boards during wave soldering. Mainly between the pins of the SOICs there are small solder balls. Maybe somebody had the same problem and could solve it. Please give me some ideas what causes this problem and how it
Electronics Forum | Tue Jun 29 00:23:11 EDT 2010 | dontfeedphils
Is this a single PCB or a multi-up array? At the very least you should probably pick up a universal wave pallet, check out AGI or DMI. -Phil
Electronics Forum | Thu Jul 01 15:12:16 EDT 2010 | siddharth
Thanks to all for their inputs. @Hexielectronics, I am now trying to assemble the board by attaching it to a frame and removing the frame while waving it. I plan to put the boards back on the frame after the board cools down. Could you explain more
Electronics Forum | Fri Jun 18 17:36:10 EDT 2010 | sid
Good afternoon all, I have been trying to find a solution to a defect I just noticed. After stencil printing and smt part placement on the secondary side of my boards, I run them through a wave soldering system. All my components got soldered perfe
winsouce.jpg)
