Electronics Forum | Wed Nov 13 04:12:20 EST 2013 | hqew2013
Do you design or define PCB layouts? If so circuit board, what rules and checks do you have in place to make sure your results are... optimal? Over the years, I've created a PCB design checklist to keep me out of trouble. I share these nuggets with m
Electronics Forum | Thu Jan 27 08:52:05 EST 2000 | Todd A. Braun
We currently use a silicon conformal coating on many of our manufactured circuit boards and are experiencing situations where the coating doesn't conform. For example, on the sharp edges of components and corners of leads it pulls away before curing
Electronics Forum | Thu Jan 27 17:54:37 EST 2000 | Steve Harshbarger
Casimir, I have seen exactly what you are experiencing with the Kester 958 on other wave lines. No clean fluxes vary in how much flux residue is visually left behind. These no clean residues are typically not harmful to the PCB, but they are often
Electronics Forum | Thu Feb 04 16:08:05 EST 1999 | Ryan Jennens
| I realize it's been discussed many times before. I need to know your opinions, experience, and knowledge concerning "today's"/latest and best pallet designs, suppliers, and methods for using them more effectively. | | Thanks much, | | Earl Moon |
Electronics Forum | Sat Feb 02 23:16:17 EST 2002 | caldon
STIMPMAN- Dave is correct Teflon has to be going somewhere. Solder is also expensive and to be dragging it around the fingers on your machine is not cheap either. (I am sure Debbie could recomend a reclain system ). Some times the pain is either fron
Electronics Forum | Wed Apr 17 02:30:03 EDT 2002 | seje
Hello. There is been a lot of talk about thick plastic stencils vs. metal stencils for adhesive printing, but how about thin plastic stencils? We used to use a very thin plastic stencil (from loctite) with printgap (=snap-off) to adhesive printing
Electronics Forum | Wed Jun 19 14:44:11 EDT 2002 | kenbliss
It sounds like your inspector improved quality and pre-staging your feeders dramaticaly increased uptime on your machine, thats great to hear. One cautiionary note, be careful not to flood your production area with parts off of your SMT line. With
Electronics Forum | Sun Dec 22 06:00:54 EST 2002 | Mark
Hi: Your stencil specs are good; Did you check the stencil thickness? It would be worth a ck since there may be an error from the stencil mfr If the paste is not releasing with good stencil specs, these are possible causes: 1 The paste isn't tou
Electronics Forum | Tue Feb 17 10:55:49 EST 2004 | bobbyv40
Hi Dave, 1. As far as speed of removing componants, we use a board preheater to bring board temp to about 150 C. Then add a flux and then flood all 4 sides of the componant with the low temp solder. Using a suction tool the part comes right off. The
Electronics Forum | Thu Jul 14 09:42:36 EDT 2005 | saragorcos
Our facility helps customers clean no-clean soldered boards on a regular basis, and it definitely can be done but is a little more challenging than boards built with water soluble flux - one piece of advice I would give is to use low water pressure (