Electronics Forum | Tue Jun 03 11:19:19 EDT 2014 | rmazenha
Hi, Which dissipative ESD floor is the best for an industrial usage? - vinyl - epoxy Thanks
Electronics Forum | Wed Jun 25 03:13:54 EDT 2014 | Kristof_K
Hi, > > Which dissipative ESD floor is the best > for an industrial usage? > > - vinyl - > epoxy > > Thanks Epoxy look much better and it was cheaper than PVC/vinyl. The surface isn't as smooth because fastidious to the smooth and horizontaly
Electronics Forum | Tue May 07 07:31:15 EDT 2013 | davef
Pavel You're correct that you should consider the point loading of your placement, wave and other machines. I've put shops above the ground floor of buildings. Equipment suppliers are the best source of information about these requirements. BR, dav
Electronics Forum | Wed May 15 11:13:36 EDT 2013 | pavel_murtishev
Davef, Could you tell me if you filled your floor by additional concrete layer during your shop construction? Have you had any placement machines stability issues? Your input would be really valuable. Thank you.
Electronics Forum | Thu May 02 15:29:19 EDT 2013 | jim_n_hky
I can't answer your specific question on the floor, but I have some suggestions. The equipment manufacturer should be able to provide the floor loading requirements. A structural engineer should be able to translate that into specs for hte constructi
Electronics Forum | Tue Apr 30 05:05:16 EDT 2013 | pavel_murtishev
Colleagues, Now I am involved into plant ramp-up where 3x Panaconic NPM-W will be installed. New production hall is being designed right now and the problem is that constructors have never met SMT shops and know very few or next to nothing about requ
Electronics Forum | Mon May 06 05:32:39 EDT 2013 | pavel_murtishev
Jim, Thank you for the input. Could you please check your standard filter pore size? A model number would be valuable. How many shop volumes (in cubic meters) do you pump per hour? Customer is seriously thinking over installing AC system similar to
Electronics Forum | Mon May 06 21:40:40 EDT 2013 | davef
ANSI/J-STD-001: * Temperature and Humidity: 18-30°C, 30-70%RH ** If out of range, shall verify electrostatic discharge control program according to ANSI/ESD S20-20 is adequate. ** For process control, more restrictive temperature and humidity limits
Electronics Forum | Tue May 07 03:56:30 EDT 2013 | pavel_murtishev
Davef, Thank you. I wonder if you have ever faced with concrete layer thickness selection for SMT shops? All I have found refers to metal treatment shops (primarily milling & drilling). 6" concrete is thick enough for them to stabilize milling machi
