Electronics Forum | Tue May 16 16:04:17 EDT 2017 | kkay
Any one happen to have an Electrovert econopak plus 400/f floppy boot disk that will run the machine?
Electronics Forum | Thu Oct 22 14:37:27 EDT 2020 | kumarb
Hi. Did a similar update to our Emerald-X (YV88X) and the USB Floppy Drive emulator works like a champ! Installed within a few minutes with 100% success. Way more elegant than 1.44M floppies. Can you share more details on the FD Emulator you have so
Electronics Forum | Thu Jun 09 03:03:31 EDT 2005 | meritajs
We have problem with floppy disk for YM84s, YM66s We do not have diskettes backup copies and mounter can not start to operate.We have ecspierience with PHILIPS CSM84V without diskeetes What could be recomend?
Electronics Forum | Sat Dec 16 22:43:56 EST 2006 | Ola
Hi, If I remember correctly (it has been about 15 years since i worked with one of these.)The old MCS machine is based upon a Motorola 6800/68000-series Micro processor and the operating system is OS/9 from Microware Systems Corporation. This was a r
Electronics Forum | Mon Jan 25 17:20:55 EST 2016 | tombstonesmt
I'm guessing a field engineer with access disk will be the only person that can update or install recognition software. I just verified our machine does have a recognition version in that field. I would call Panasonic Factory Solutions and ask.
Electronics Forum | Tue Sep 13 10:40:01 EDT 2011 | kahrpr
Check the drive make sure it is not going bad. Also most newer floppy disks are not very reliable.
Electronics Forum | Fri Aug 26 09:39:21 EDT 2022 | compit
The emulator doesn't work that way. You can create only 1.44 MB partitions (e.g. 100 pieces on one flash drive) (with the supplied software) and they will be visible as floppy disks. It is not a USB port.
Electronics Forum | Tue Feb 27 05:54:19 EST 2007 | m7mdshms
I want to replace my FDD with a driver to read flash memory instead of Floppy disks, but uses the ordinary floppy interface on pc mother board
Electronics Forum | Wed Jun 19 11:34:37 EDT 2013 | chifutbol
"The disk of B drive has not been formatted as a PCB Data disk." This is the error I'm getting when trying to install lines on a new installation of the Gemline PCB Editor. I have tried using a new floppy, formatted in both opal and topaz machines,
Electronics Forum | Fri Oct 27 10:43:08 EDT 2017 | sumote
i believe someone has left a floppy disk in the drive. eject it and reboot.
