Electronics Forum | Tue Jul 29 17:59:53 EDT 2014 | guts1872
I have had to flush the ram when replacing a TEP controller. These are kind of scetchy instructions from my notes, never could get PPM to send me any procedures. Hope this helps. Plug keyboard and monitor into RT computer and navigate to 2kla/RT/TEP
Electronics Forum | Thu Jul 25 14:18:34 EDT 2019 | babe7362000
It's been awhile but I was wondering if anyone knows how to read the LED's on the Tep board to what they mean. Top 4 Red 1. blinking red 2. lit red 3. off 4. lit red 5. lit red 1. blinking green 2. not lit 3. lit green 4. off 5. off On the Gui
Electronics Forum | Thu Jul 03 11:27:06 EDT 2014 | bobpan
Try these things: 1. Reseat the cards (with power off) and Reboot the machine and see if the errors clear. 2. Unplug the nozzle changers and try to reboot....sometimes they can mess up the system. 3. If all the above fails.....the b-rams in the card
Electronics Forum | Thu Jul 25 16:20:59 EDT 2019 | bobpan
Top red led is on or off depending on version of tep board. The green leds light when the transport sensor that it communitcates with is seeing a board over it. Tep controller init failure can be one of the following. 1. Check reseat tep card and
Electronics Forum | Mon Feb 06 19:56:07 EST 2006 | bobpan
Ok....that is very vague...but here is the approach i would take. 1. rename permanen.tbl file and reboot 2. rename calibrat.arc file and reboot * both files are located in c:\2kla\gui\guiqsv1* If it fixes the problem....it was a software issue. 3. If
Electronics Forum | Wed Jul 30 03:03:12 EDT 2014 | torch
cheers turns out it was both, cards needed reseating and also the ram flushed :) its back up and running now :)
Electronics Forum | Thu Aug 08 11:04:48 EDT 2019 | btfonseca
Hi everyone, I was recently trying to troubleshoot a bad floppy driver on our QSV-1, which actually worked, I was able to read floppy drives but for some reason it all went downhill when one of the green LED's turned off and another red LED turned on
Electronics Forum | Tue Nov 25 08:36:32 EST 2014 | bobpan
Tep stands for the transport card. The board is located in the front bottom left of the machine and should be by itself and have green and red leds lit on the top of it. I would try to reseat the card and then try to reboot the machine. If the proble
| 1 |
