Electronics Forum | Tue Jan 31 02:59:18 EST 2006 | jgarver1
You also should check to make sure you have blow off at the placing station set properly. I have seen machines with the flow control valve shut completely off not release parts properly. The parts end up in the scrap bin and the machine thinks they
Electronics Forum | Thu Sep 20 13:28:23 EDT 2001 | ohanlon
Here is how the FormFlex system conforms to component variations. The FormFlex system utilizes an oil chamber that is common to ALL the pins once the system is set. Pushing down one pin will cause the displaced oil to be shared by all the others pins
Electronics Forum | Wed Sep 19 09:34:08 EDT 2001 | jschake
Both FormFlex and Grid-lok tooling systems are marketed as compliant tooling systems. Both are able to conform to the variations of the topography on the bottomside of a substrate to provide full support during printing of 2nd side assembly. The ba
Electronics Forum | Wed Jun 11 16:30:33 EDT 2003 | T.Vick
You have received some great feedback so far. I would like to summarize and add a few points regarding maintenance. You should start (as recommended already) by verifying your component library data. Using the default values from the master library i
Electronics Forum | Fri Mar 16 10:04:41 EDT 2012 | davef
We'd repair a drop board like this. Here's what our old friend Jeff Ferry said is a published article ... When boards lose their edge: when the corner of a circuit board breaks or is damaged, the problem cannot be ignored by Jeff Ferry One of the m
Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef
Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we
| 1 |
