Electronics Forum | Thu Jan 18 12:30:19 EST 2007 | slthomas
Change pastes, although insufficient heating may leave excessive residues. Is this on one board or all products? No Clean or water soluble? Do you profile accurately or "guesstimate" your settings?
Electronics Forum | Wed Apr 28 14:52:03 EDT 2010 | davef
When we hear the words 'flexible circuit' and 'delamination' in the same sentence, we think: * Excessive reflow temperature. * Entrapped moisture. Boardhouse: I hope this is a step towards redemption.
Electronics Forum | Thu Mar 17 03:07:17 EST 2005 | Chua
Hi, We are running lead free at wave solder now and the spray flux system is down. If we are going to able the flux manually, what problem will we be facing with the excess flux able. Appreciate for the advise.
Electronics Forum | Fri Jul 23 14:41:41 EDT 2004 | Steve Stach
Dear JSK, It sounds like the root causes of your problem are two fold. First, excessive heat will polymerize the abietic acid found in rosin forming neo-abietic diamers and polymers which are much less soluble than the parent monomer. There are
Electronics Forum | Thu Mar 17 22:14:42 EST 2005 | Chua
Hi Davef, Thanks for your advise...... We are running no-clean process. If there is white residues after few days.....is it cause by those excess flux. Thanks
Electronics Forum | Thu Mar 17 10:14:30 EST 2005 | davef
If you're washing the boards properly, you should see any problems, maybe a little extra floaming, but that won't be too bad. If you're running no clean, you need to aplly flux according to your supplier's recommendations. If you decide not to foll
Electronics Forum | Thu Mar 17 22:47:29 EST 2005 | davef
That would be our first guess, also. Get the stuff analyzed to be sure. Another clue is if the white stuff disappears when you hit it with hot air from a rework station. The hot air is activate the flux. Good troubleshooting tool, but you're subj
Electronics Forum | Fri Dec 01 07:46:41 EST 2006 | davef
Bridging Causes: * Insufficient flux * Excessive pre-heat * High conveyor speed * Solder contamination
Electronics Forum | Tue May 22 08:39:23 EDT 2012 | davef
Bridging Causes: Insufficient flux, excessive pre-heat, high conveyor speed, solder contamination [AIM Solder]
Electronics Forum | Mon Sep 24 11:12:56 EDT 2001 | nwyatt
Hi. We are currently using an unconventional method to rework a micro BGA - removing component with hot air, fluxing the area, placing the part with pick and place, then reflowing it in the oven. The reason we are doing it this way and not with a r
.png)
