Electronics Forum | Thu May 13 20:38:32 EDT 1999 | lima
Does anyone know of any industry guidelines for the exhausting of volatiles in reflow ovens? I've seen some numbers like 1,000ppm for the oven atmosphere, but is this typical? My concern is the volatiles in my WS629 solder paste may be attacking th
Electronics Forum | Fri May 14 00:16:28 EDT 1999 | Mike D.
| Does anyone know of any industry guidelines for the exhausting of volatiles in reflow ovens? I've seen some numbers like 1,000ppm for the oven atmosphere, but is this typical? | | My concern is the volatiles in my WS629 solder paste may be attack
Electronics Forum | Fri May 14 15:03:19 EDT 1999 | lima
| | Does anyone know of any industry guidelines for the exhausting of volatiles in reflow ovens? I've seen some numbers like 1,000ppm for the oven atmosphere, but is this typical? | | | | My concern is the volatiles in my WS629 solder paste may be
Electronics Forum | Tue Jan 23 23:28:54 EST 2007 | jovial_guy23
If you have flux deposits on the cooling plates, try out Zestron's VIGON RC101...It is an extremely good product especially for reflow ovens and wave solder systems. Check it out...Minimal maintenance water based chemistry with no flash point...Much
Electronics Forum | Thu Jun 16 22:33:54 EDT 2005 | davef
Peter: Please explain: * You say, "The cooling phase is important to perform the strength of the solder joint." [We agree that fast cooling rates produce fine grain in solder and that fine grained solder connections are stronger than coarse grained.
Electronics Forum | Mon Jun 14 11:44:10 EDT 1999 | Vince Gedgaudas
Has anyone had issues where bottomside double reflowed smt has fallen off in the wave when using voc-free flux? I have verified the hotter profile was not the issue by using an alcohol based flux with no problems.This voc-free flux is also not causin
Electronics Forum | Thu Feb 15 13:49:10 EST 2007 | russ
only plug one side, you can definitely blow out during reflow process with a sealed via/ it is impossible for flux to be trapped in a blind via. Russ
Electronics Forum | Thu Jan 18 12:21:57 EST 2007 | tonang
How to reduce flux contain on PCB after reflow process?
Electronics Forum | Tue Jun 15 12:03:27 EDT 1999 | Dave F
| Has anyone had issues where bottomside double reflowed smt has fallen off in the wave when using voc-free flux? I have verified the hotter profile was not the issue by using an alcohol based flux with no problems.This voc-free flux is also not caus
Electronics Forum | Tue Aug 22 08:52:39 EDT 2000 | genesmelik
Good morning Dr. Lee. I was wondering how flux chemistries have changed, or will change, with the transiton to Pb-Free, given the higher reflow temperatures required for SMT assembly?
