Electronics Forum | Fri Dec 16 10:25:37 EST 2005 | solderiron
Rather than cleaning a water soluble flux residue off the board, by encapsulating the product. covering the board or the component with lets say a Hysol encasulant. Would this prevent the active flux residue from migrating and deteriorating the elect
Electronics Forum | Fri Jun 25 16:18:26 EDT 2004 | waveroom
For what its worth. Even though you are potting the boards. If for whatever reason flux residue (OA) was left on the board prior to potting this flux could migrate and cause embrittlement problems with the solder joint. I would definately inspect for
Electronics Forum | Thu May 05 11:55:52 EDT 2005 | jimmiem
Was it determined what caused the flux migration?
Electronics Forum | Thu Mar 20 15:14:48 EST 2003 | swagner
Does anyone out there have any experience printing with the new synthetic pastes? The problem I am experiencing is flux migration under the screen that I do not see with my other suppliers, any help would be appreciated. Thanks,
Electronics Forum | Thu May 05 11:50:03 EDT 2005 | russ
Just went through this with a customer. Removed BGAs and noticed discolered pads at some locations. It was determined that these were open connections that had some type of flux migration between the ball. They also took solder readily. This may
Electronics Forum | Wed Feb 18 12:13:50 EST 2004 | babe
my experience tells me you should have no problem. However please remove the flux residues from the board. Unless of course this is a product that is inexpensive and you don't care about degradation/flux migration etc. In example an electronic toy. T
Electronics Forum | Thu Nov 07 07:35:23 EST 2002 | cyber_wolf
If you are experiencing flux migration, try refrigerating your paste when not in use. This causes the flux viscosity to go up. I have seen flux seperate from the solder is when it is VERY old and out of date.Sometimes warmer ambient temperatures wi
Electronics Forum | Sun Aug 13 08:54:19 EDT 2006 | davef
electrochemical migration What flux are you using?
Electronics Forum | Wed Feb 07 16:16:10 EST 2007 | mr
I have seen this before. Check: --Vibration of belt --Interference (part getting "brushed off" while reflowing bottom-side components --Some glues' cross-linking mechanism is impaired by the flux during migration in reflow, redering the glue useless
Electronics Forum | Thu Nov 07 04:24:24 EST 2002 | Yngwie
Thanks for the reply guys...It was much appreciated. On syringe or Cartridge - what about the impact of flux migration, there was a talk about, periodically we need to turn the cartridge or syringe upside down to ensure the metal content & flux are a
winsouce.jpg)
