Electronics Forum | Thu Sep 23 11:56:30 EDT 2004 | rkevin
We are printing on an assembly using SAC305 Alloy Sn96.5 Ag 3 Cu .5 with a no clean flux and getting virtually NO spread with either a ramp to spike or straight ramp profile. We are printing to standard FR4 board with immersion Ag finish. I am trying
Electronics Forum | Thu May 20 22:42:19 EDT 1999 | Dave F
| hi everybody, | We've been doing some studies on assembly of CSPs. We assembled these packages on micrivia-in-pad patterns. These are 15/13.5/11 mil pads with 6 mil design microvia, using photo/laser/plasma tech. We are seeing voids, as big as the
Electronics Forum | Fri May 30 04:20:59 EDT 2003 | Ben
Hi all I am facing the problem with reoworking CSP component for high frequency application boards. Our customer do not allow us to use tacky fluxes due to high frequency application and component has low standoff ,and the ball pad and ball size is
Electronics Forum | Tue Nov 13 21:59:42 EST 2007 | davef
This processes has the potential to cause barrel cracking and pad lifting, because the heating is very hot [troop crank-up the volume on their iron when they see thick boards] for a relatively small area on one side of the board. What do we suggest
Electronics Forum | Tue Sep 20 23:12:38 EDT 2005 | darby
Several suggestions. Your hands may be tied but here goes. 1. Doctor your stencil so that pads are not shared etc and reduce the apertures more that what you would normally. This may stop one pad wetting into another etc. 2. The use of a Pb-free sol
Electronics Forum | Fri Oct 10 20:56:50 EDT 2014 | jlawson
Main issues... Pad Design Thermal Mismatch Design related to pads effected Moisture and out gassing in substrate / part terminations can move parts slightly during preheat prior to liquidous this get position shift ( smaller the parts more an issue)
Electronics Forum | Fri Sep 15 16:30:13 EDT 2006 | russ
yes there is Caveman, (well maybe depending on your circumstances) you need to purchase a manual printer and print the connector then flip and print the other side. (you need a manual printer so you can print after the parts have nbeen reflowed, we
Electronics Forum | Mon Mar 15 16:07:32 EST 1999 | Earl Moon
| | After rmoving a BGA (plastic)to correct unexplained shorts | | I installed another BGA using flux only. | | Checking on an X Ray machine and found two shorts. | | | | can anyone give a good explenation ? | | | | Thanks | | | | Ron | | | Ron,
Electronics Forum | Fri Mar 29 10:11:02 EDT 2019 | cyber_wolf
“For a number of years now, work has been proceeding in order to bring perfection to the crudely conceived idea of a transmission that would not only supply inverse reactive current for use in unilateral phase detractors, but would also be capable of
Electronics Forum | Fri Jul 10 13:55:16 EDT 1998 | Bob Willis
After reflow the paste on a copper pad should spread out from its original print dimensions it should ideally not prior to reflow as that is a hot slump. The better the solderability of the OSP or the higher the activity of the flux will greter flow
