Electronics Forum | Sun Feb 13 01:35:55 EST 2000 | Dean
Without further information my first guess would be lack of flux to "cut through" the ENTEK layer. Question: In X-ray is the suspect ball of equal diameter when compared to adjacent balls? If no then the volume of solder is different which would po
Electronics Forum | Thu Jun 07 18:09:21 EDT 2007 | stephan
We noticed unsufficient soldering on some 0805 chips located between pins from a plastic bloc connector . All chips are soldered with 45� angle. Flux quantity , preheating , contact time and PCB quality was checked. Do you know any international stan
Electronics Forum | Wed Aug 10 07:55:21 EDT 2005 | ajaydoshi
we are using heareous F381, F352 no clean solder paste. specially in qfp for high frequency board we observe that cleaing / removing of ' no clean flux 'is require. if we do not clean same most of time after all test & envioumental test it shows pin
Electronics Forum | Tue Jan 14 19:41:32 EST 2020 | avillaro2020
Hi Evtimov, Thanks for your response. Yes, the vapour phase is suppose to handle big and heavy boards, at least thats the intention. Well our thin board is like around 3mm which is not really thin. In our application the thicker the boards means more
Electronics Forum | Wed Apr 19 04:41:42 EDT 2006 | ge_lim
Hi I am using selective soldering to dip soldering the connector pins to the PCB and would like to know your experience: a) Is there a recommended dip or dwell time for the dip soldering? b) How do we improve the solder coverage in the TH? c) How t
Electronics Forum | Fri Jan 28 12:18:32 EST 2005 | Chunks
Your best bet is to do a decision making matrix. Each company has so many different criteria�s it's hard to pick out which one might be important to yours. Simply pick out your top 5 paste manufactures. Next decide what your "Eliminators" are - th
Electronics Forum | Thu Jul 03 19:27:54 EDT 2008 | proy
5 Zone HVA70 Oven Board 6 layer, 10" x 13" lots of space, most critical is 100 pin QFP AIM Water Soluble 487 Tin Lead paste on SN100C HASL boards This board is giving me disproportionate grief! I am running 23 in / min which gives me about 3.1 mi
Electronics Forum | Fri Dec 08 06:34:55 EST 2006 | Rob
Try flux buster ICT pins.
Electronics Forum | Mon Aug 30 15:43:22 EDT 2004 | ryufoong
i will try on it. Thanks a lots. Regards, CHEN
Electronics Forum | Mon Mar 13 06:11:08 EST 2006 | Rob
Surely this is a job for Wavemaster Larry? Have you tried flux buster pins in your ICT yet? They are quite good at cutting through the crap on a board.
winsouce.jpg)
