Electronics Forum | Thu Mar 02 11:20:25 EST 2017 | tombstonesmt
Our Senju Sparkle Flux contains 8% solids and is a NC.
Electronics Forum | Thu Mar 02 10:50:22 EST 2017 | emeto
Hello, I am looking for a NC flux that has more solids. Anybody using anything that has at least 7-8% solids contents?
Electronics Forum | Mon Mar 06 15:51:38 EST 2017 | bk
The one i've been using on some thermally diverse boards with great success has been henkel loctite mfr 301. It's alcohol based not quite the solids you are looking for but close it's 5.5-6.5 solids and it is no clean.
Electronics Forum | Fri Mar 03 10:42:19 EST 2017 | bk
What kind of flux you looking for water based, alcohol based, or solvent based
Electronics Forum | Thu Mar 02 12:20:40 EST 2017 | emeto
Would you specify a part number?
Electronics Forum | Fri Mar 03 13:15:55 EST 2017 | emeto
Both Alcohol and Water based should work. I will try to stay away from Rosin/Resin because of the residue - issues in ICT.
Electronics Forum | Tue Mar 07 07:26:43 EST 2017 | emeto
Thank you bruce! I tried similar rosin based 6.5% but it gives me a lot of residue. Anything water based?
Electronics Forum | Thu Aug 28 09:30:20 EDT 2008 | patrickbruneel
Omid, No-clean fluxes need to be used right out of the can without thinning. In the past with RA and RMA fluxes you could adjust or thin them to your desired density because they had plenty of solids up to 30%. No-Clean fluxes have a lot lower solid
Electronics Forum | Tue Dec 19 16:26:24 EST 2006 | samir
Grant, Newer lead-free fluxes have 6%-10% solids content - more activator, therefore leave more "visible" residues. Old technology tin-lead fluxes got down to as low as around the 4%-6% range (I'm going off memory, so me might be wrong)... You'll
Electronics Forum | Fri Jun 12 11:15:50 EDT 1998 | Ryan Jennens
Hey all! The wave solder warrior is back. I have found a flux which leave almost no residue (the least yet), but because of its super low solids content I absolutely cannot get topside fillets. The multi-layer, two sided board is on a pallet w