Electronics Forum | Mon Jun 12 10:57:51 EDT 2000 | Jason
I am new to wave soldering. Any information is greatly welcomed. Here is the problem. After soldering the boards they have a film on the bottom of them and sometimes a white powder looking substance. I have tried decreasing the amount of flux on
Electronics Forum | Mon May 07 11:25:21 EDT 2007 | colormaker
Flux foam is not affected by board or pallot. This wave is not the same as the hollis I used. The hollis wave flowed from middle to left and right side. This wave only flows to the left and its a very slow wave. Jerry
Electronics Forum | Fri Nov 11 04:13:23 EST 2005 | arnold
we are manufacturer of molded type transformer and we soldered are units using wave soldering machine and then we washed the units to remove flux residue. what materials or any process for us to eliminate the process of washing after wave soldering.
Electronics Forum | Mon Jul 29 19:21:58 EDT 2002 | davef
Look to: * Your flux supplier's recommendations to baseline your recipe [similar to using your paste supplier's recommendations for setting your reflow recipe] * 7530 'Guidelines for Temperature Profiling for Mass Soldering (Reflow and Wave)' for gui
Electronics Forum | Fri Feb 20 02:09:23 EST 2009 | nibirta
Hi all, I have a question regarding some wave pallets having metallic traces of Titanium. The solder mask is blistering in some locations on the PCB and I am wondering if this Titaniumn may have an influence by incresing locally the temp. Also we ar
Electronics Forum | Mon May 07 10:27:40 EDT 2007 | colormaker
The spray bottle puts more flux on the board but I am not sure how to measure ? I just got the Novastar 12S and its very difficult to set up. When I fix one problem another one show up. When I do get good results I dont make changes and then after a
Electronics Forum | Mon Feb 23 05:37:23 EST 2009 | emmanueldavid
Necoleta, PWB Blistering/De-lamination may not be due for Titanium finished threads / holders which is typically being used to draw high Shelf Life of Pallets and even flow across Auto Wave Soldering rails. There is also nothing to suspect on Liquid
Electronics Forum | Sat May 05 18:18:22 EDT 2007 | colormaker
I am using a Novastar 12S solder wave with Kester water soluable fux 22-2425. I have used this for years without problems on an old Hollis machine. Just started using the Novastar and after fine tuning I get itermitten bridging on the front of the P
Electronics Forum | Mon May 07 16:00:38 EDT 2007 | patrickbruneel
Dave, There is not really a �smart� or scientific way to check this but I know of easy ways and very effective ways. Fex. an easy way to check is with a 3� spatula, you hold the spatula at the same angle as the board and drag trough the wave simula
Electronics Forum | Thu Sep 13 15:44:02 EDT 2012 | mbnetto
Hi everbody, I'm facing some soldering problems with a Diode (SMA) during wave soldering process. During this process almost all the time one of the component pads have no solder, according to the picture dsc000604 attached. Some considerations: * T
