Electronics Forum | Fri Dec 15 11:01:14 EST 2017 | robertorocco
I have one Topaz X FNC machine with this problem. The head 2 FNC not change the nozzle. The head 4-6-8 is ok and change, but head 2 no, when he tries to change the nozzle he gives me an error message. What could be the problem?
Electronics Forum | Sat Mar 10 16:51:53 EST 2018 | ramsus
how can i make a CM602 pansonic machine program from an FNC file.I am a beginner in programming I use DGS console and PT200.can you help me PLZ
Electronics Forum | Thu Nov 08 02:09:05 EST 2018 | vinitverma
If the nozzle gets changed properly but the machine still gives the sensor, then the FNC nozzle detection sensor needs to be adjusted. It is a set of 2 sensors on a plate on the either side of the FNC. If the nozzle is not changed successfully and ge
Electronics Forum | Thu Nov 24 01:45:44 EST 2005 | pavel_murtishev
Good morning, My advice is to put two Topaz-Xii in line. Machine programming is rather easy (with PPS and GPP that AssemleOn offers), but final teaching on machine is strongly required. If you want to prepare programs fully offline you�ll have to pu
Electronics Forum | Mon May 17 10:59:02 EDT 2021 | kumarb
Hi. Have an Emerald-X machine with FNC purchased refurb from Assembleon with mixed results at 3500 hours. Had it sitting idle for years due to assorted issues after their installation. Only now after much time and parts investment have the machinery
Electronics Forum | Wed May 19 20:11:21 EDT 2021 | compit
I have two machines - Emerald-X and Topaz-X. I cleaned (and changed Koganei electromagnets) only in Topaz-X - Emerald-X is in very good condition :) But my Emerald-X have SF (not FNC) heads. If head 1 is OK - change the relays with head 2 and check.
Electronics Forum | Wed Jun 24 14:42:03 EDT 2020 | kumarb
Hi. Heck no! First, you should find out the Yamaha equivalent of your machine, if known - that is a more common reference when sourcing parts. While we have no affiliation with the vendor other than a very positive history of sourcing a laundry list
Electronics Forum | Fri Jul 09 17:52:43 EDT 2021 | glasscake
Hello, I have a Topaz-X that is losing its R origin as it runs. The issue can be seen in the following test: Set the machine to ignore vacuum/ignore alignment and have no feeders in the machine also set the nozzles all to fixed. I run a servo orig
| 1 |
winsouce.jpg)