Electronics Forum | Tue Dec 05 17:10:50 EST 2023 | aksaustin
Is this happening in the mornings? Are the operators allowing the machine to come up to set temperature before they run it?
Electronics Forum | Wed Dec 06 12:37:04 EST 2023 | stephendo
We have a batch washer. When it was being installed I noticed their was some foam when testing empty. We had already ran a load previously. I asked the installer and he said that it takes very little for there to be foam.
Electronics Forum | Tue Nov 14 18:55:16 EST 2023 | kghadiya
I relate to your problem. We face this issue sometimes. It's mostly flux from SMT, TH process or rework boards. To avoid foam in our Washer, we soak the boards in hot water for 10-15 min before running it through the washer. Or you can spray the boar
Electronics Forum | Mon Dec 18 19:31:33 EST 2023 | kojotssss
Surely somewhere the cleaning or rinsing liquid gets to the other chamber. It is possible that the chemical migrates to the flush or flushes the chemical into the chamber. I have had a similar situation, high foam, injection vertical spray offline st
Electronics Forum | Wed Dec 13 15:19:32 EST 2023 | hhudson
It has been happening in the mornings, and we do have a weak middle element, but our temp is always above 60C. we have it set at 65C. the service manager for the machine assured us that temperature wasn't the issue. Also, our flux application for ERS
Electronics Forum | Thu Mar 21 09:23:35 EDT 2024 | alishakihn
Good morning! I'm sorry to hear about the anomalies you're experiencing with your inline wash. Dealing with foaming issues can be challenging, but I'll do my best to provide some suggestions to help you troubleshoot the problem. 1. Check the Water Q
Electronics Forum | Tue Nov 14 14:08:44 EST 2023 | hhudson
Good Morning, I'm a relatively new engineer, and i've been experiencing a lot of anomalies when it comes to our inline wash. We have an Austin American Hydrojet, and no matter how many times i clean the tank, it still foams like crazy! its been happe
Electronics Forum | Thu Jun 28 17:14:44 EDT 2012 | davef
Here's a pretty good thread from the fine SMTnet Archives on water wash foaming http://www.smtnet.com/Forums/Index.cfm?CFApp=1&Message_ID=50623
Electronics Forum | Thu Jun 28 09:40:49 EDT 2012 | austinpeterman
We just stepped into the inline wash world with a techical devices new clean galaxy plus. We are noticing a significant amount of foaming when washing our boards after selective solder. One theory is that the water soluble flux used is not being cu
Electronics Forum | Thu Jun 28 16:02:05 EDT 2012 | allwave
We had a similar problem with foam in our inline cleaner (TD). The problem were the solder paste flux residues. Boards went straight from SMT to Wave process and then washed. Anyway we changed the solder paste and problem solved. Are you using saponi
.gif)
