Electronics Forum | Wed Jan 08 10:54:19 EST 2003 | dphilbrick
As Russ says this should process well the BIG BUT..T is what are you using to process this part! How old / capable is your equipment. Screen print quality is a must. Placement accuracy is critical and reflow stability is important. So the answer is d
Electronics Forum | Wed Jan 21 15:10:30 EST 2015 | ahernand75
VCD equipment is a single-process sequencing and insertion of axial components and jumper wires. Cheers!
Electronics Forum | Tue Sep 14 00:26:47 EDT 2010 | sachu_70
Besides selecting an efficient soldering station, the geometry of the iron tip and its maintenance thereafter is extremely critical to equipment performance during the soldering process.
Electronics Forum | Mon Apr 30 22:41:29 EDT 2007 | davef
Cross: IPC nor anyone else calls out recommended pressures for washers used to clean circuit boards. IPC and the other standards setting folk are in the business of defining the expected results or outputs of processes or acceptance criterion. They
Electronics Forum | Tue Feb 25 09:09:53 EST 2014 | alpha1
Rob, If you're still looking, please note that we can help you with pre-production line and process set up. Everything from paste selection, stencil ordering, pick and place programming and reflow recipe.
Electronics Forum | Wed Nov 07 17:57:01 EST 2007 | jmelson
OH! He he, St. Louis! I have recently acquired a very good P&P machine, and am in the St. Louis area. I got the machine primarily for my own manufacturing, but there is plenty of time available on the machine. If you'd like to see how the process
Electronics Forum | Wed Nov 07 15:50:52 EST 2007 | Frank
For a modest invest of capitol equipment and maybe some hair pulling to learn the process it shouldn't be terribly difficult to get your own production line up and running. You just missed a few trade shows that you could have went to and seen all t
Electronics Forum | Mon May 15 13:55:00 EDT 2000 | Aldo
We are in the process of researching manual or low cost automatic Tape and Reel equipment. I have heard about V-tek and Systemation. I would appreciate if someone can tell me any problems or virtues of theses two brands that have been experienced. Al
Electronics Forum | Fri Nov 02 16:22:49 EDT 2012 | jorge_quijano
Hi folks, I'm trying to develop a method to evaluate new SMT equipment, we will need to invest in a new SMT line soon, so I have to evaluate what machines would fit our manufacturing process, I'm thinking in create a matrix and evaluate every machine
Electronics Forum | Wed Jan 17 13:33:23 EST 2007 | slthomas
We're in the process of trying to select a rebuilt, refurbished, or well serviced flexible placer, something that's capable of placing in the neighborhood of 10k and up. We're a high mix low volume shop so easy setups is key. I'd be looking at a MY-9
