Electronics Forum | Fri Jan 04 14:42:20 EST 2013 | mcox
Philips Gem Topaz - Does anyone have a decoder ring for calculating the correct place angle for components. I am looking for a fool proof way to program the correct angles depending on how the parts are supplied to the machine. Thanks Mike
Electronics Forum | Fri Jul 30 11:32:31 EDT 2004 | westred
I am looking for a fool-proof way to have operators measure PCB's out of the depaneler to ensure that the tolerances for the outside edges are being met. Probably a spot check system to make sure the process is in tolerance. So far building a "GO"
Electronics Forum | Tue Jun 05 14:04:11 EDT 2007 | hussman
We have the same situation here. But generally it is the customer gives us a 1-up Gerber drawing and we need a multi-up or some form of breakaway to make the product. The way we achieve this is thru a Word document we call PCB Guidelines. We attac
Electronics Forum | Sat Oct 20 19:33:59 EDT 2018 | reckless
My pick and place machines are 10+ years old so I might be in the crappy department. I wasn't looking for a complete fool proof system, I am looking for aoi on a tiny budget that covers majority of scenarios. We will have to be mindful of solder sl
Electronics Forum | Fri Dec 10 12:40:44 EST 1999 | Brian W.
It sounds like the process is very labor intensive, and all the verification is done after the parts are soldered. Assuming you are hand placing the components: 1 - Contact Systems semi-automatic placement machine. It show polarity when placing, so
Electronics Forum | Thu Sep 11 11:45:33 EDT 2008 | swag
Never did find a fool proof solution. Solderability seemed O.K. (at least using the methods we have available in house). Tinned parts and placed by hand and saw little improvement. Pad design is slightly different than recommended but likely not i
Electronics Forum | Wed Sep 10 14:14:03 EDT 2008 | gregoryyork
Yes why did the Electroless Nickel layer split this is the ROOT cause. My guess is still that the resist was slightly miss registered over the copper and therefore poor adhesion of the Nickel ensued OR like I said originally the resist had contaminat
Electronics Forum | Wed Aug 08 12:20:51 EDT 2012 | swag
We have a Kaeser AS-25 screw compressor with Kaiser air dryer + cylinders. The system has a water catch prior to delivering air to the dryer that automatically "spits" to a drain. It's not fool proof - if the water collector gets overfull, it will
Electronics Forum | Wed Jan 12 08:41:01 EST 2005 | davef
Se�or Tech QC Inspection stamps: * VRS Marking, 567 Camino Mercado Ste. A, Arroyo Grande, CA 93420, 800-782-6790 805-481-9787 Fax: 800-743-3135 Fax: 805-474-1238 contactvrs@vrsmarking.com http://www.vrsmarking.com * Des Moines Rubber Stamp Works, 8
Electronics Forum | Mon Aug 27 08:58:24 EDT 2012 | rway
Reese, > > We would agree about the value of an > ICT system, in a general manufacturing > environment. However, a couple of notes > apply: > > 1. ICT isn't a catch-all, either, and > should be used to verify the process, not > validate it.
winsouce.jpg)