Electronics Forum | Tue Apr 27 22:17:32 EDT 1999 | Clint Meech
Can someone please supply me with a footprint for a SOT 426-L, or at least point in me the direction of where I could find one.
Electronics Forum | Wed Apr 28 08:08:45 EDT 1999 | Dave F
| Can someone please supply me with a footprint for a SOT 426-L, or at least point in me the direction of where I could find one. | | Clint two sources for ya: 1 Check with your component supplier 2 Use the following link Good luck Dave F
Electronics Forum | Mon Feb 19 10:04:21 EST 2007 | realchunks
It's a nasty little part, but usuallu solders well. Now your inspectors will thing it's not soldered and try and touch it up, but generally, the exposed leads are not tinned, and will not toe fillet. If they know this up front they won't over heat
Electronics Forum | Thu May 26 11:21:14 EDT 2011 | asksmt
Hello Guru's, I am using IPC-7351 LP Calulator to design Footprint (0603, 0805, 1206, SOT-23, etc) for all SMT Parts. Our Production Recently commented that they have included Red Glue Machine inhouse and will use Wave Soldering for Both Thru-hol
Electronics Forum | Tue Aug 12 07:35:23 EDT 2008 | stevezeva
Hi, Is the footprint per the component manufacturers recommendations? The reason I ask is because it kinda looks like the pads are extending beneath the component. Could cause the part to float up on top of the solder and not allow the leads to wet
Electronics Forum | Sat Mar 19 04:31:37 EDT 2022 | SMTA-69080803
What are the feasible options in mounting an alternative component onto a PCB that has a different footprint? PCB redesign is not a good option because the component is used on several other PCBs. The component is very small (8-lead SOT-23) so fabric
Electronics Forum | Thu Apr 07 20:42:19 EDT 2022 | stephendo
The boards were just a little larger than a SOT8. IIRC we had a pizza slicer type depanelizer and it wasn't too bad. We just did enough to populate the bare PCBs we had. Where I am now a customer has us put a QFP and a few other parts on a SOW28 f
Electronics Forum | Thu Oct 22 14:39:22 EDT 1998 | Chrys
| My company is looking for higher density for card layout. One suggestion has been locating active components packaged in SOT's and SOIC's on the B-side of the card. This in turn will require wave soldering of the above mentioned components. When I
Electronics Forum | Fri Jun 26 16:23:14 EDT 1998 | Steve Gregory
Hi Dave! Yeah, they've been around a while, and they're pretty straight foward like you said. About the only things that I can think of that I've run across that causes problems with these guys is when they're used on the bottomside of the board
Electronics Forum | Tue Jan 15 10:08:19 EST 2019 | griinder
I'm looking for any experienced Graphicode software users for advice. We use Gerber EZ Teach(GC Powerplace) to offline program 2D inspection on our Momentum printers. I have an issue with mirrored apertures when creating my Bottom Side inspection pro
| 1 |
