Electronics Forum | Tue Jul 19 17:48:16 EDT 2005 | saragorcos
One step is to examine the cleanliness on and around the failing component. There could be an ionic contaminant causing the shorts. Regards, Sara Gorcos www.residues.com
Electronics Forum | Thu Jul 21 14:16:56 EDT 2005 | stepheniii
Tell them every action taken with the boards carries risk of damage. Process steps that don't do anything should be avoided because they carry the risk of causing defects. Even inspection causes the occasional defect, and board handling in general s
Electronics Forum | Thu Jul 21 14:42:47 EDT 2005 | jdengler
Stephen, If you have ever gotten QC to buy into this logic you have a much better QC department than most. Jerry
Electronics Forum | Wed Jul 20 17:23:19 EDT 2005 | davef
IPC-2222 - Sectional Design Standard For Printed Board For Organic Printed Boards, Table 9-3 � Plated Through Hole Diameter To Lead Diameter Relationships will give you the standard information you require.
Electronics Forum | Wed Jul 20 14:43:16 EDT 2005 | cguerrero
I'm trying to see if anyone has used solder paste instead of glue in the MyData glue station. If so what kind?
Electronics Forum | Fri Jul 22 01:31:39 EDT 2005 | fastek
Peter- You're not going to solve this problem here. Call DEK.
Electronics Forum | Wed Aug 03 10:08:57 EDT 2005 | Me
Try this: http://www.adamtech.co.uk/support.html
Electronics Forum | Thu Jul 21 06:14:28 EDT 2005 | aj
All, I have a Conceptronic HVN70 reflow oven with Genesis Cooling System. After profiling and checking the readings, the Cooling Rate seems to be very fast. Does anyone know if the cooling is adjustable? aj
Electronics Forum | Thu Jul 21 07:15:03 EDT 2005 | cyber_wolf
Does anyone know of a good source for a tuning fork type belt tension meter. Needs to measure in HZ. Thanks, Sr.
Electronics Forum | Thu Jul 21 10:34:53 EDT 2005 | Frank
We use a meter from Gates. Works good. http://www.gates.com go there and find a distributor.
.png)
