Electronics Forum | Tue Oct 14 07:33:45 EDT 2014 | rob
Hi all, Does anyone have any experiences (good or bad) with VisionMaster 3D SPI? Thanks, Rob.
Electronics Forum | Wed Oct 15 03:59:00 EDT 2014 | rob
Are you using specific tooling for each part, or just generic? If so it could be pushing down at an angle and slightly tearing the PCB. We use the same style press as you but make custom fixtures to fit each connector and hold each PCB tight.
Electronics Forum | Fri Jan 23 13:20:44 EST 2015 | daniellarios
Well both materials are thermo plastics and recyclable. But it is diffficult to separe into streams. Do you have any process to do this?
Electronics Forum | Wed Feb 04 22:01:48 EST 2015 | daniellarios
But do you separate this waste from others. Or do you separate by plastic? Because if you do the second it would be easier to find a way to recycle. Do you use an optic sorter ?
Electronics Forum | Fri Oct 17 09:38:07 EDT 2014 | rgduval
Are you able to turn off mechanical centering? Or can you adjust the settings?
Electronics Forum | Fri Oct 17 12:48:59 EDT 2014 | cyber_wolf
The only reason you would need to run this calibration is if the camera was replaced or the centering camera got whacked which is highly unlikely. If your placements are off, put an offset in the parameter file.
Electronics Forum | Wed Oct 22 13:44:41 EDT 2014 | davef
Distributors have access to large number of connector suppliers * http://www.newyorkerelectronics.com/ * http://www.digikey.com/Connectors * http://www.newark.com * http://www.directindustry.com/industrial-manufacturer/card-edge-connector-93613.h
Electronics Forum | Mon Oct 20 18:58:13 EDT 2014 | warwolf
Has anyone had any products from this company? Just wanting to find out a bit more on the quality side of things. Regards
Electronics Forum | Tue Oct 21 21:34:56 EDT 2014 | davef
"Electroless Nickel Immersion Gold and Black Tar. What Is It and How Can It Be Prevented?" James Trainor, OM Group Electronic Chemicals, LLC SMTAI 2014 SUB2
Electronics Forum | Tue Oct 21 06:19:50 EDT 2014 | navworx
Hello, We have an MPM 2000 HiE printer. when opening the lid, the light does not come on. It looks like a typical kitchen fluorescent light fixture. Replaced the bulb, but still does not light. Does the fixture have the starter inside?
.png)
