Electronics Forum | Tue Oct 21 09:36:50 EDT 2014 | island2013
Hi Bill, Yes it does have a small circuit right behind the plate. There is a 2amp fuse in there along with some other circuitry. Perhaps your fuse went out
Electronics Forum | Fri Oct 24 19:27:28 EDT 2014 | wsp364
Do you know the maximum board size for that destacker? I left a message with a sales rep. btw- are you a Torch Lake guy???
Electronics Forum | Wed Oct 22 13:32:48 EDT 2014 | dhollland
Just curious. We use these machines and software in our facility and I am looking for others that ideas can be bounced off of when needed....and trust me, we need it frequently.
Electronics Forum | Wed Oct 22 14:55:00 EDT 2014 | rrosera
Does anyone have any experience with labels capable for withstanding both re-flow and machine wash cycle? We've tried a few different materials and the ones that make it threw re-flow wash off and the ones that make it threw was tend to melt in re-fl
Electronics Forum | Mon Oct 27 05:50:24 EDT 2014 | robl
Hi Rob, We use a Brady THT-1-457-10 for serialisation, goes through double sided reflow and aqueous or ultrasonic wash depending on customer requirements. Rob.
Electronics Forum | Mon Nov 03 10:23:16 EST 2014 | dontfeedphils
We use Brady as well, P/N THT-47-727-10, with no issues whatsoever. Dobule-sided reflow, select solder, multiple cleaning cycles, ect. Check with your chemistry manufacturer, they may have already done the leg work for you on label/ribbon compatibi
Electronics Forum | Thu Oct 23 04:19:15 EDT 2014 | garteaga
Our reflow oven builds solder on one specific panel type. It will have solder buildup inside the oven. We then end up with small solder balls on our panels. We think it may be the solder paste, the screen printer is leaving a clean wipe under the pa
Electronics Forum | Tue Oct 28 14:18:41 EDT 2014 | tombstonesmt
Spoke to the maintenance manager, master password is the current date in reverse. For example : Today is 10/28/2014 so... 41028201 Level 3 should be pass3. Hope this helps.
Electronics Forum | Wed Oct 29 10:36:33 EDT 2014 | blainemoran
Looking for a maintenance mode on the NPM-W where I can isolate and fire different components. For example if I suspected a bad motor is there a way to just attempt to fire that. Any advise?
Electronics Forum | Wed Oct 29 18:08:35 EDT 2014 | tombstonesmt
Good afternoon. Not sure if this is available at an engineer level. Perhaps and SD card with field service access is necessary. We have two lines with NPM-W's and the most we've been able to do is actuate vacuum on the heads during flow checks.
.png)