Electronics Forum | Mon Feb 11 09:48:07 EST 2019 | neiderman3140
To connect the DEK printer and the KY SPI you will need to add the SPI closed loop upgrade to your DEK. It is a simple software and cable connection.
Electronics Forum | Fri Feb 08 10:52:24 EST 2019 | roblackey
BLT 31-41 "No Clean Selective Flux For Aerospace" On a Versaflow 3/45 Atomises well, good hole penetration, good wetting, cleans off well in the solvent cleaner. Use for SN100C, SA0307, and 60/40.
Electronics Forum | Wed Feb 13 13:30:03 EST 2019 | emeto
I personally prefer a NC process if I have to chose. AIM flux was good NC377 I think(they keep changing names), NF 372 from and many more. You can make them all work...the KISS 104 ...
Electronics Forum | Fri Mar 22 14:19:38 EDT 2019 | gregcr
Thank you ProcEng1 Nordson sent me a flux suggestion list: No Clean: 1. Kester Select 10 2. ALPHA EF-2210 3. AIM FX-16 Water Sol: KESTER 2331-ZX Nozzle Tinning: SUPERIOR #75
Electronics Forum | Tue Feb 12 17:55:44 EST 2019 | spitkis2
Hi Joe, I work for an equipment manufacturer and we have processed RF housings before so I know they are challenging in terms of thermal mass. Let me know if you are available to discuss your application details and what would be a good email addre
Electronics Forum | Wed Feb 13 09:37:01 EST 2019 | SMTA-Joe
I will look into using an oven to raise the module's temp when I have the chance. This could be our only way to use existing technology that only allows for temps below what we're seeing.
Electronics Forum | Wed Feb 13 11:06:01 EST 2019 | jimpat
I believe the end user is working with an aluminum housing - something like this http://www.boainc.ca/UserFiles/product/JP01-600x490.jpg with a PCB mounted inside. Not very user friendly material especially for IR as its reflective.
Electronics Forum | Wed Feb 13 12:39:17 EST 2019 | SMTA-Joe
Would we be able to schedule a demo for this model? If so, would this have the IR top heater as well? In the event IR bottom heating does not work, are there models with alignment/placement assistance that we can just use with a conventional hotpla
Electronics Forum | Wed Feb 13 13:26:17 EST 2019 | pace_worldwide
If you could send your email address to acaplan (AT) paceworldwide (DOT) com, I could arrange a demo through one of our Representatives.
Electronics Forum | Thu Feb 14 10:54:11 EST 2019 | SMTA-Joe
This sounds like a workable solution in line with what I'm looking for. What company do you represent?
.png)
