Electronics Forum | Tue Nov 20 15:03:37 EST 2012 | jaimebc
Bruce, Since we had spares, I replaced the X wagon cables, XFMB cable, nothing. FFX Cable, nothing. Swapped mot cards, nothing. Vaccum seal, nothing.At this point I truly believe the problem is either on the theta encoder or the theta motor. Unfortu
Electronics Forum | Fri Nov 16 15:55:40 EST 2012 | pctech
I am desperately in need of 200 Maxim chip " DS 2710G+ " , contacted manufacturer about this chip and learned that they will not be available untill April.I have to finish a customers order by the end of January.Is there any one out there that they s
Electronics Forum | Fri Nov 16 17:49:07 EST 2012 | davef
Services, Parts, Distributors, Hard to find parts * SolTec Electronics soltecelectronics.com * Cross Components crosscomponents.com * Farnell / Electronic Component Distributors farnell.com * TTI Inc ttiinc.com * SearchlightTech searchlighttech.com *
Electronics Forum | Thu Nov 22 12:04:00 EST 2012 | rgduval
According to the look-up on the ESB, PRB Logics reports 1284 stock. As always when using brokers, there's likely to be an inflated cost, and a potential for counterfeits. http://www.sourceesb.com/ProdSearch.asp?regid=0&search=DS2710G+&sname=PNS&typ
Electronics Forum | Tue Nov 20 11:57:25 EST 2012 | torch
has anyone ever tried running these devices through a reflow process soldering the tab to the pcb then soldering the TH connections? we have a device which needs fitted but we are soo tight for space that we cannot use a conventional screw/nut to hol
Electronics Forum | Mon Nov 26 13:07:16 EST 2012 | rway
Running in series is best for less change-over, depending on how many components you use. But, as Dave stated, if you have the capacity on your machines to run your product on one machine, then you can do that and get twice the throughput. Series wi
Electronics Forum | Wed Nov 28 16:30:31 EST 2012 | rgduval
We've just acquired a batch washer at an auction, and want to install it as a closed loop system. The only problem is I have no idea where to turn or what to look for for a drain filtering system that will allow us to make it a closed loop system.
Electronics Forum | Sat Dec 01 13:43:51 EST 2012 | anvil1021
Do you mean the Paste Layer of the Gerber files? If so then you can check for aspect and area ratio of the component apertures (which is determined by the thickness of the stencil) there is an IPC specification for this and it is IPC-7525A I believ
Electronics Forum | Mon Dec 03 09:53:40 EST 2012 | anvil1021
Well there are 2 ways to go about this, the first would be to have your stencil provider do the calculations for you (with his software) or you can purchase LPKF CIRCUITCAM EDIT from LPKF. This is a Gerber editing software that is designed to make st
Electronics Forum | Sat Dec 01 13:51:26 EST 2012 | anvil1021
In my experience with flex the flex provider is the best place to go for these pallets. The competent flex and rigid flex providers will also provide the carriers if requested. Once you see what they are providing you, you could most probably make th
.png)
