Electronics Forum | Thu May 20 02:46:01 EDT 2004 | Jo
�Now I can use Idle gas mode but I want to set N2 Idle Time because it will work when the furnace empty instantly So, the question is How could I set N2 idle timer and pressure regulator ,
Electronics Forum | Thu May 20 12:05:12 EDT 2004 | Rob
I got one sitting in my room that is not being used. It meets SMEMA standards and is from Conveyor Technologies Model# REF-CC-1M-1-BR. If you are interested, I can put you in contact with someone who can talk with you...
Electronics Forum | Fri May 21 06:59:17 EDT 2004 | pjc
Hi Cal, Here are two sources for good used J.O.T. conveyors: Insertech- NE www.ine-inc.com Recon www.reconsales.com
Electronics Forum | Fri May 21 09:04:24 EDT 2004 | Cal
Rob- Is it safe to asume this is a flat belt conveyor? or an edge belt? I can talk to your contact if need be. thanks cal
Electronics Forum | Fri May 21 13:41:56 EDT 2004 | bradlanger
Cal, Check out a company called JMW. They are in your area and have a large inventory of used conveyors. 507-864-7477
Electronics Forum | Thu May 20 14:22:39 EDT 2004 | dougm
I need some advice on how to run a test with some large boards through the re-flow oven. The boards are 17"x17", 3/16" thick. Withought destroying one of the boards, how would I go about getting a good temperature profile?
Electronics Forum | Thu May 20 16:00:12 EDT 2004 | mrmaint
Doug, If you are worried about cooking the board. Take a know profile and either reduce the heat in each zone or increase the belt speed.This should keep you from cooking the board. then adjust the profilr to the board from there. MrMaint
Electronics Forum | Thu May 20 15:54:35 EDT 2004 | mrmaint
Looking for some feedback from users of the pace TF1500 BGA rework station. How is the unit working? Have you had any issues with repeatability. Thanks MrMaint
Electronics Forum | Tue Jun 01 17:07:13 EDT 2004 | older/wiser
This is what you might expect from a economy (cheap) system. I have profiling problems, not repeatable. Underboard heater problems, temp. inconsistent depending on color. I'm stuck, so be careful!!!
Electronics Forum | Fri May 21 10:32:17 EDT 2004 | cyber_wolf
How do you get the boards out of an Omniflow 10 oven in the event of a power outage ? I don't see any place for a hand crank, but I do notice that there seems to be a UPS in a cabinet toward the end of the oven. How do I test it ? Thanks.