Electronics Forum | Thu Nov 03 21:44:28 EST 2005 | fastek
Isn't it nice when someone has a problem that is replyed to by many and the original poster actually lets everyone know in the end what actually fixed the problem? It doesn't happen enough...so thanks to you Sean.
Electronics Forum | Tue Oct 11 14:10:51 EDT 2005 | Amol
Hi, I have a very basic question for tin whisker testing. Do I thermal cycle/age the Components only or solder them to a ckt board and then thermal cycle/age the PCB assembly??
Electronics Forum | Tue Oct 11 14:23:49 EDT 2005 | tttone_98
Looking to purchase SMEMA cables to connect a Fuji conveyor to a Fuji CP. Does anyone know were I could purchase them..
Electronics Forum | Tue Oct 11 14:58:52 EDT 2005 | vikkaraja
You do not need to buy any special cable for this purpose. Fuji normally has 2 pins connector attached at the end of each equipment. Now if you do not have those connectors, you can just buy some 2 to 4 conductor cable from your local electronic supp
Electronics Forum | Wed Oct 12 13:49:17 EDT 2005 | russ
Most likely happening during the cooling phase. I also produce many of these joints with no reliability, DOA, or field failures to date (thousands upon thousands). Contact your paste supplier and they will give you the technical stuff on what you a
Electronics Forum | Wed Oct 12 20:55:53 EDT 2005 | mikaelsuhairi
Hi We have BGA sockets that are soldered on our PCB which required cleaning? Anyone have any solution as for now we just use compress air jet to clean it. We found this is not effective in the long run. Any comment?
Electronics Forum | Thu Oct 20 05:58:19 EDT 2005 | Slaine
Hi could be relaited to the thermal mass of the screw/bolt. if there is no intermatalic formed and the solder just picks off id say this is likely. the hot wave hits the cold screw and cools the solder enought to leave some behind??
Electronics Forum | Fri Oct 14 03:53:59 EDT 2005 | lupo
Hi, What is the speed of the conveyir (contact time) and alloy: Pb free or not? Temperature of bath? Quantity of flux? Regards
Electronics Forum | Fri Oct 14 08:12:48 EDT 2005 | lyrtech
For LUPO: speed: 4.5 inch alloy: 63Sn/37Pb Solder pot temperature: 500 Quantity of flux: just to wet the board
Electronics Forum | Fri Oct 14 18:01:18 EDT 2005 | Mika
I Am SORRY; I mean of corse ING. I must be tired, because I start mix one author whith the next one. Just imagine what I will do with the alloys :-) Sincerly,
