Electronics Forum | Wed Jan 10 21:03:02 EST 2024 | madisreivik
Vision error found: YOU MUST CHANGE LAMPS SOMETIMES ! Also, the camera front-glass (with the cutout) must be correctly positioned :) Still looking the Q error on left head. Probably mechanical problem...
Electronics Forum | Thu Jan 11 12:42:55 EST 2024 | richardcargill
if the battery failed then you will have lost all the Cmos settings it held relating to the disk drive configuration/availability. Jump into the PC setup at switch on and make sure everything is correct
Electronics Forum | Fri Jan 12 14:08:32 EST 2024 | calebcsmt
That makes a lot of sense - I appreciate the insight and clarity. In regards to the choke, such as: RN114-0.8-02-27M for example, would you also recommend not coating the body of the component of chances of effecting inductance? Or since it is en
Electronics Forum | Fri Jan 12 15:32:53 EST 2024 | madisreivik
Indeed I found some vacuum problems, one replaced small hose was not fitted correctly. Lets see if that helps :) Great thanks ! Also, Travis, do you have any information how to adjust the milk-plexiglass slitted covers on line scan cameras ?
Electronics Forum | Fri Jan 12 14:05:33 EST 2024 | rygenetic
Hi @calebcSMT, It is generally recommended to avoid coating the entire body of aluminum electrolytic capacitors. These capacitors rely on the venting of gas in case of failure or overvoltage conditions, and coating the entire component could hinder
Electronics Forum | Mon Jan 15 08:54:40 EST 2024 | SMTA-64304553
Trying to understand the impact of iron contamination above IPC recommendations (0.02%) on selective solder joints. Brittleness and discolouration are known but are there other factors that should be accounted for?
Electronics Forum | Tue Jan 16 16:15:03 EST 2024 | madisreivik
Have you considered laser marking ? Cheap chinese lasers can vaporize soldermask and leave "dark copper" marking.
Electronics Forum | Wed Jan 17 15:07:34 EST 2024 | rmrshield
BIRAL is a HEAD cleaning oil it's not a overall HEAD clean the inside of nozele picker only
Electronics Forum | Wed Jan 17 22:28:35 EST 2024 | dwl
In the spirit of engineers not answering the question but providing an alternative solution, have you considered using adhesive labels? for very low volumes you can hand place them. for higher volumes, you can get them on reels and place them with th
Electronics Forum | Thu Jan 18 07:22:10 EST 2024 | klauss
Is there any stardarts to help us what tolerance values (max or min. height, weight, volume etc) should we use while programming AOI and SPI.
