Electronics Forum | Sat Jan 19 23:23:45 EST 2008 | bentigano
I'm not familiar with SPC Plus. I'll assume it's a "statical process control" system. We use the SPC data collected by our YesTech AOI system, together with a custom, web-based reporting system for process analysis and defect reporting. I am actually
Electronics Forum | Thu Dec 06 14:59:50 EST 2007 | ch
Hi All! Thinking about purchasing 2nd user Panasonic p&p machines (CM88s-M1 or MSR series...) but I didn�t know anything about it�s programming. So, I wonder do I have to use any off-line software by anyway or it is possible just to load centroid dat
Electronics Forum | Fri Dec 07 15:12:56 EST 2007 | teodor
Hello , I would like to collect your valued opinions what is better for beggining . Samsung CP-45NEO Juki 2060 Light Feeder Positions (8 mm) 104 80 PCB Size (min - max) 50x30-460x400 mm 50x30-410x360 m
Electronics Forum | Wed Dec 12 12:08:30 EST 2007 | realchunks
Yes, you can ask for scrap boards, buy Dummy boards/parts or engineer off past runs. For this cost, I would profile, profile, profile. I would make/buy a dummy board. If you don't have one this thick, glue/ adhesive/ bolt some scrap boards togeth
Electronics Forum | Thu Dec 13 10:39:38 EST 2007 | lloyd
Hi Mefunak, I'd say that the vacuum holding circuit is at fault. If the component is picked OK from the feeder ('vacuum check after pickup' is switched on) then the component is being dropped from the head as the gantry moves to the placement positi
Electronics Forum | Fri Dec 21 00:06:55 EST 2007 | nhantruong
If you want to use fuji CP6 machine, you have to buy the the fuji flexa software.Because the old software from fuji (MCS or F4G) they are not support anymore. In the flexa software you can make top and bottom side in the same program, you can move th
Electronics Forum | Fri Dec 21 15:50:54 EST 2007 | rwyman
Hi smtdude- I'm no expert at PoP (yet!) as we've only done a few weeks worth of experiments for a new customer but what i can tell you is 25-50% of the ball height (not diameter) is a good rule of thumb for the flux depth, at least to start. I can s
Electronics Forum | Mon Dec 17 19:18:53 EST 2007 | bbarton
OH MY GOD!! Finally it's becoming public knowledge here on the streets. YES germanium is in this material. As much as these guys and ALPHA METALS wanted to keep these things secret, anyone with a halfway competent lab would quicky find out why all of
Electronics Forum | Mon Dec 17 13:58:54 EST 2007 | ck_the_flip
I made my own wave measuring device using KIC2000 system. KIC2000 has automatic wave detection, so now I have a profiler for both reflow ovens and wave solder. The delmat carrier only cost $500. A guy, Samir, from this forum gave me the idea, actu
Electronics Forum | Mon Dec 17 19:01:45 EST 2007 | bbarton
As someone with a LOT of experience with the "low cost" alternative alloys, primarily SACX, I have one simple question....Are these shorts a new phenomena? WAS your process in control, and all of a sudden it's not? If the answer is YES, take a look a