Electronics Forum | Wed Mar 05 10:02:47 EST 2014 | dyoungquist
Per the TPSys Version 2.4 Software Manual: Force sensor level not within limits. * Force sensor dirty (inside Z tool holder) * Bad force sensor connection Try this: Remove the tool from the Z Midas head. Take a cotton tipped applicator (Q tip) and
Electronics Forum | Thu Mar 06 17:27:17 EST 2014 | bobpan
Does this happen with just 1 gantry? If so...I would think your encoder in that gantry/axis needs cleaned. I have seen digital i/o cards cause this issue. But usually you will notice this when opening and closing the doors. The head would sometimes
Electronics Forum | Thu Mar 13 14:12:31 EDT 2014 | davef
You're creating a new alloy on the surface of your board. The alloy will have a melting point determined by the constituent metals of the alloy. Your alloy consists of: * Lead-free HASL solderability protection on the board * Lead-free solder paste *
Electronics Forum | Thu Mar 20 14:58:04 EDT 2014 | aybars
We use IQ feeders from PPM and cant find any > reference material on maintenance and calibration > of these feeders. Does anyone here know where I > can get repair manuals, diagrams, or any info on > these feeders at all? Hi guts1782, IQ feed
Electronics Forum | Wed Mar 19 19:19:41 EDT 2014 | dave222
thank you for taking the time to look at this post. hopefully someone can help. I have a GSM2 Q block with a Flexjet 7 spindle head. a couple of days ago the machine encounter this issue while zeroing. the issue is with head 2 on beam 2. on the di
Electronics Forum | Thu Mar 20 15:57:57 EDT 2014 | edwaterfall01
The numeric display number should be higher but only when all 7 spindles are moved down slightly from the full up position. The 7 spindles retract up to the Stop Bar. Each spindle assembly has a tapered hole thru it. This hole is in the block with t
Electronics Forum | Mon Mar 24 20:30:01 EDT 2014 | davef
The "correct" answer is: Use the tests and methods that you used to qualify your solder paste in the first place. That sounds good but might not be all that practical for practicing assembly-types. Here's something that's not as good, but will give
Electronics Forum | Sun Mar 23 21:34:38 EDT 2014 | jmelson
I have a 3 head CSM84 without vision. I have set up head 3 without chuck jaws to use with the mechanical alignment station. When I got the machine all the M.A. offsets were zero. Over time, I have gotten them closer, but I really don't understand
Electronics Forum | Fri Mar 28 00:13:29 EDT 2014 | jmelson
I was hoping somebody knew how to do this. My method was to place parts at 0 and 180 degree rotation, and adjust head offset until the parts were in the same position at both rotations. Then, I adjusted the M.A. station offset to zero in on correct
Electronics Forum | Tue Mar 25 14:19:02 EDT 2014 | barryg
Hello everyone. I have a question pertaining to solder irons, tips and solder stations. We recently have set up our lead free wave and reflow oven. We still have quite a few projects that require leaded solder. I was curious how others handle rework
.png)
