Electronics Forum | Thu May 04 01:52:17 EDT 2023 | davef
Look at IPC-7526 - Stencil and Misprinted Board Cleaning Handbook, Misprinted Circuit Board CleaningCLEANING [ https://www.multi-circuit-boards.eu/fileadmin/user_upload/downloads/leiterplatten_design-hilfe/ipc-7526.pdf ] ITW/EAE says "Typically, th
Electronics Forum | Tue May 09 14:30:47 EDT 2023 | gwideman
I realize this request is an incredible longshot, but... Anybody happen to know the initial default username and password for ERSAsoft 2.1? We have a hard-working antique Hotflow 3, and decided to try setting up ERSAsoft for it. Comes on two floppi
Electronics Forum | Wed May 10 01:40:26 EDT 2023 | gwideman
UPDATE: By some miracle, a paper manual has been found for the ERSAsoft 2.1 software. Turns out that the default user and password are "System". So in addition to that gem, I guess an additional contribution of this thread is that despite the manu
Electronics Forum | Fri May 12 07:41:15 EDT 2023 | tommy_magyar
Although I see the advantages in your method, not sure though how to deal with the following: 1. Your batch is actually only one board (or panel) - this would not work in a low volume manufacturing environment, unless there are other jobs set up on t
Electronics Forum | Thu May 25 01:46:10 EDT 2023 | frankchan
Hi, I would recommend something from 21 Century at least. Considering it's mostly small batches there's no reason to raise the budget to purchase the Newest series. I think the principle here is something that'll do and do a nice job. If you are a Ya
Electronics Forum | Thu Jun 01 00:20:25 EDT 2023 | ultraview
We are using a Kayo-A4 SMT machine and are running across software bugs we can't seem to work around. Video here: https://youtu.be/PSobXzTtcH0 I push next and the camera goes to the correct location for part J2. Then I push test and the part is picke
Electronics Forum | Thu Jun 01 22:47:27 EDT 2023 | spoiltforchoice
most, possibly all of our clients, don't specify this kind of thing even when they are in fields where you might expect they should and should be aware of them. However if you cherry pick a couple of class 2 requirements such as offset and joint widt
Electronics Forum | Tue Jun 06 00:53:55 EDT 2023 | frankchan
Hi Rob, my previous offer to you assumed you would stick with Yamaha, if others suit you then we could also supply. If Why no one recommends Samsung/Hanwha you ask, from the seller's point of view, Samsung's market is majorly in China, with about 2~3
Electronics Forum | Tue Jun 06 13:19:27 EDT 2023 | oxygensmd
It is really strange you don't have EKRA on your list. EKRA are really good for protos and mass-production too. We have E5, X5 and two X4Prof. X4Prof are lasting forever if you handle and maintenant them properly. ESP001 and Simplex softwares have t
Electronics Forum | Tue Jun 06 13:47:10 EDT 2023 | oxygensmd
In Hungary there are many EKRAs. Bosch, Zollner and many big/small company are using them. I also saw the latest DEK but I think DEK is over-complicated, fast and good printer - but if you have any problem, it cost a lot. MPM also nice machine but I