Electronics Forum | Fri Dec 21 00:06:55 EST 2007 | nhantruong
If you want to use fuji CP6 machine, you have to buy the the fuji flexa software.Because the old software from fuji (MCS or F4G) they are not support anymore. In the flexa software you can make top and bottom side in the same program, you can move th
Electronics Forum | Thu Mar 01 06:12:18 EST 2018 | reckless
I am new to SMT and need to buy a pick n place machine that runs ~7500 cph and super reliable/no headache. My budget is $10,000. Either I buy seriously used (~15-20 years old gsm) or new Chinese unit. I saw this video and am seriously considering
Electronics Forum | Thu Mar 01 11:18:56 EST 2018 | reckless
EVTimov, Thanks for responding with your thoughts. I appreciate it! In regards to your thoughts, my biggest issue is we do use alot of 0402 components. This unit is probably built on their success of their simple table top unit which no one has
Electronics Forum | Thu Aug 26 13:20:56 EDT 2004 | pjc
Machine design plays a major factor in actual placement rate vs. the published tact time max speed. For example, random access horizontal turret head machines can vary greatly depending on nr. of different components and size ranges, while the dual g
Electronics Forum | Fri Jul 02 16:16:53 EDT 1999 | Scotty
| | I am currently looking into ways to decrease SMT changeover times. I work in a high mix-low volume factory. We use Fuji CP's and IP's for SMT production. I would appreciate hearing from anybody that has some proven methods for reducing setup/chan
Electronics Forum | Wed Jun 04 20:09:01 EDT 2003 | stefwitt
The tact time is determined by the slowest machine in the line. In your case it is 4.5 min. This is the time from the board leaving the output conveyor sensor to the next board leaving the sensor. The first machine, which finishes the job in 3 min. h
Electronics Forum | Wed Oct 10 17:47:49 EDT 2007 | jmelson
Does it give any more info about the error? Is this in the stage after you've hit run, it says "initializing" and it is counting up on the screen? Usually it gives a little more info, although it can still be cryptic. I have run into it stopping w
Electronics Forum | Sat Jul 03 13:49:36 EDT 1999 | JohnW
50% reduction in time. One draw back, the availability of feeders... You need 280 feeders max to change over a max capacity of 140 feeder machine (or a variance of a product mix vs. part numbers); then there's 8mm, 12mm, 16mm, sticks feeders that c
Electronics Forum | Fri Jul 02 14:32:44 EDT 1999 | Dave F
| I am currently looking into ways to decrease SMT changeover times. I work in a high mix-low volume factory. We use Fuji CP's and IP's for SMT production. I would appreciate hearing from anybody that has some proven methods for reducing setup/change
Electronics Forum | Fri Jul 02 14:50:39 EDT 1999 | Earl Moon
| | I am currently looking into ways to decrease SMT changeover times. I work in a high mix-low volume factory. We use Fuji CP's and IP's for SMT production. I would appreciate hearing from anybody that has some proven methods for reducing setup/chan
