Electronics Forum | Fri Apr 07 17:44:17 EDT 2006 | bobpan
You can either optimize both boards from the very start to the same table top or you can assign the feeders under configure tabletop to the same spot that they were in when you optimized the first program. Remember that you can optimize many differen
Electronics Forum | Thu Aug 23 04:17:10 EDT 2007 | hannua
In the VIOS file between lines &B.MNT and &B.OPT you will find the index number (in hexadecimal, four digits just in front of the reference designator in each line) into the component and feeder table. The feeder table entries are designated with &F
Electronics Forum | Thu May 08 17:58:22 EDT 2003 | Ozzy
Chrissieneale, Have you invested in additional feeders and feeder tables to prepare for the next job offline while running the current job? If your changeovers take as long as you suggest then this should be a quick ROI.
Electronics Forum | Fri May 16 12:14:04 EDT 2003 | pjc
The UIC HSP (Sanyo), like Panasonic MV MS and Fuji CP, are random access turret type chip-shooters. Having a split carriage, typically 2x 60, 2x 70 or 2x 80 input carriage tables, allows for faster changeovers provided you have enough positions on ea
Electronics Forum | Fri May 01 04:10:35 EDT 2015 | dberenguer
We recently purchased a Quadra Laser P&P machine from another company. The machine is in good conditions and we've been able to test most of the hardware functions of the machine, including fiducial recognition, feeders and header exchange. We feel
Electronics Forum | Wed May 22 10:27:33 EDT 2002 | stefwitt
Fiducial recognition on the Siemens machine works like the Mydata. Once you select this option, fiducials will be recognized when a new program is send. You can also select recognition as part of the feeder refill function mode. There is no automatic
Electronics Forum | Thu Sep 29 11:44:47 EDT 2005 | stepheniii
What kind of volume? I've done boards that I think were longer on a standalone mydata. The boards hung over the end of the table and we had to leave the feeder bank to the right of the table empty. But later we did the same boards on a panasonic. I"
Electronics Forum | Mon Apr 24 07:37:57 EDT 2006 | craig_83
We have the IQ system. The problem that I was having is that when I load one board to the other, I want to avoid the table top changeovers. So I figure if I can make certain tabletops to run certain boards the changeovers would be much less. I though
Electronics Forum | Sat Dec 05 22:08:21 EST 2009 | casmt
MY9 - 19 are all the same machines. The frame is only bigger. With the 19 you can get up to 256, 8mm feeders if it has the stand table. Ocourse that is an advantatge it can handle large boards with a big table. I have used Mydata a many companys. A
Electronics Forum | Fri Dec 14 18:32:39 EST 2007 | kroberson
What machines have you worked with previously? Depending on the programming software used, CP6 can be relativly easy to program. CP6 has been a workhorse in the industry for a long time. One the process is set up, maintain the machines acording t