Electronics Forum | Thu Jul 01 21:50:32 EDT 1999 | Big K
I am currently looking into ways to decrease SMT changeover times. I work in a high mix-low volume factory. We use Fuji CP's and IP's for SMT production. I would appreciate hearing from anybody that has some proven methods for reducing setup/changeov
Electronics Forum | Tue May 13 11:12:41 EDT 2003 | k_h
I currently am doing it. Keep in mind the parts are split up, such that, the chips are on one machine and the IC's and odd parts are on the second. It takes much more time to place IC's and odd parts because they need to be handled slower and often c
Electronics Forum | Thu Jun 29 08:57:07 EDT 2006 | jdengler
You have given little detail for anyone to help. What types of components are laying in the machine? Are these components missing from the PCB? But you can check these things. 1. Check vacuum at nozzles 2. Check for obstructions in the path of the
Electronics Forum | Wed Nov 29 08:25:28 EST 2006 | aj
Hi, I work mainly with Fujis but have some experience with Panas. If you are seeing components upside down on the board it is feeder related . If you are seeing poor alignment across the board , firstly I would check the xy table for alignment. Mak
Electronics Forum | Mon Jan 29 15:49:08 EST 2007 | rmitchell
Hi, Our Fuji CP65 nozzles are jamming in the up position. Mostly on caps and resistors, the .7mm (0402) and 1.0mm (0805) and 1.3mm (1206) sizes. They seem to be catching internally where the little peg slides down the slot. If you twist them they
Electronics Forum | Wed Dec 30 12:58:10 EST 2009 | vetteboy86
I'm setting up a matrix tray for the first time on our Quad QSP-2. I believe I have defined the tray and holder. Assigned part numbers. My issue is that instead of teach feeders, I think I need to teach table top. When I do this, I am not finding an
Electronics Forum | Wed Jul 16 06:54:36 EDT 2014 | alexeis
Hi, The answer is very complex depends on the type of machine, the operator's capabilities and process. There are machines that let you perform the above side then stick carts into the machine and produce. Event such a process is the length of a few
Electronics Forum | Sat May 02 03:17:01 EDT 2015 | dberenguer
Thanks Sarason, I will take a look at your software ASAP. In the meantime, I've been able to answer my own question. Feeders can be associated to components by using the same component name in both tables. It's very simple in fact. These TWS Quadra
Electronics Forum | Tue May 05 14:57:48 EDT 2020 | greezmky
I will have to check the nozzles to see if they are stuck up, but I don't believe so as I changed them all out a couple weeks ago. I have not went back to the feeder yet because I am not getting vision errors. I was able to see the diodes fly off on
Electronics Forum | Thu May 07 10:48:07 EDT 2020 | greezmky
Yeah my post disappeared as well? I checked to see if there was an offset and there was not. I tried step mode and all was good. I DID get to capture one video in, slow motion, and it shows the part being placed, the nozzle rising, and then when
.png)
