Electronics Forum: fp mode (Page 1 of 1)

MPM AP/A Problem

Electronics Forum | Mon Sep 10 10:42:49 EDT 2007 | chrisgriffin

Set "FP" mode to 1 in the setup menu 1. It won't fix your problem, but it might help a little. What kind of board support system are you using?

MPM UP2000

Electronics Forum | Wed Sep 30 06:31:07 EDT 2015 | mervin

Thanks SWAG, I have checked the FP mode, I am aware of this. I have also worked on this machine some over 10 years ago but not as a service engineer. So I aware of the programming on the machine its just trouble shooting this particular machine is n

MPM UP2000

Electronics Forum | Wed Sep 30 05:10:28 EDT 2015 | aemery

SWAG does make a good point. The tool he is talking about is located on setup page 1 in the vision box and is labeled FP Mode (Fine Pitch) mode. BY default the setting is "0" this means that once the machine is put into auto mode the camera or visio

MPM UP2000

Electronics Forum | Wed Sep 30 06:22:23 EDT 2015 | mervin

MPMENG, Thank you so much for taking the time to help. The machine has Y snuggers and flippers. The Pcb is loading in the center all the time. The driver cards look fine there is no obvious faults on them or partially burned. The machine was not in

  1  

fp mode searches for Companies, Equipment, Machines, Suppliers & Information