Electronics Forum | Wed Aug 23 09:35:35 EDT 2000 | JAX
Andy, AOI is a worth-while tool for verifying part placement on those pesky little telecommunication boards that are too small for referance designators. It can also be a valuable verification step to reinforce quality control. Pros and Cons o
Electronics Forum | Tue Jan 30 17:36:59 EST 2001 | slthomas
Looking for recommendations for references on quality an process control.....SPC, process capability (cp, cpk), etc. My feet are a little wet on this stuff, but we'll be implementing soon so I'll need a reference to bail me out on occasion. You kn
Electronics Forum | Mon Jun 14 15:29:49 EDT 1999 | Sergio Luiz Vito
I am looking for more information about: 1) What kind of evaluation can I do to measure the resistance to fall off of a bottom side glueded SMT component?; 2) There is some influence of doble wave solder machine (temperature, flux, etc) in SMDs fal
Electronics Forum | Wed Jan 06 22:59:22 EST 1999 | Tim
Any idea what the "industry standard" is for fall out on assembled PCB's? I realize that the controls put in place in your processes will effect your overall quality. But I'm trying for a general answer. On pre-tested assemblies, should you expect
Electronics Forum | Wed Mar 27 10:32:29 EST 2002 | barryg
hello evryone. I am rleatively new to smt production. Though we have been successfully running pcb assy's and getting very good solder quality we are trying to get some proccess control parameters set up for our printing process. We have a semiauto s
Electronics Forum | Thu Apr 18 17:29:00 EDT 2002 | dason_c
The industrial standard is follow the R.O.S.E test as a guideline per J-STD-001 and the limit is 10ug/sq. inch. Different tester with different equivalent factor with the ROSE and you can refer back to the manual, the Zero Ion tester with equivalent
Electronics Forum | Mon Jul 29 11:08:39 EDT 2002 | Rob Fischer
How about Kulicke and Soffa? They've been making their wire bonding equipment there for years and have finally decided to do all of their manufacturing there. I think we're all faced with the same concern and it is frustrating because there are ver
Electronics Forum | Fri Aug 16 10:58:36 EDT 2002 | kenbliss
Hi Steven www.smta.org, http://www.ipc.org are two industry association sites that have lots of information and technical papers. As far as efficiencies try http://www.blissindustries.com click on Bliss University, there is a lot of unbiased
Electronics Forum | Tue Oct 22 12:43:05 EDT 2002 | Brian W.
I think you need to define what it is you are looking for. Changeover time, Efficiency and measuring run time to your quaoted time are important, as is quality. You need to look at all of these things to determine the "health". It does you no good
Electronics Forum | Mon Feb 24 20:37:01 EST 2003 | davef
Key Food and Drug Administration [FDA] Compliance Guidelines are in: * Blood/Biotechnology * Cosmetics * Drugs * Food * Medical Devices * Positron Emission Tomography The medical device industry adheres to the rules of Good Manufacturing Practice (G