Electronics Forum | Wed Oct 13 11:54:48 EDT 2004 | raj_nz
We use a Yamaha YV100XT pick and place machine, we have just discovered this new error, during operation or resetting after making some changes on production data the machines freezes and the keyboard and controller freezed. to get it back to working
Electronics Forum | Mon Jun 12 09:42:49 EDT 2006 | mmjm_1099
Hello all, I am having an issue with my QP341 when it reads fiducials. It will be running fine than it will freeze when it goes to read a fid. When I reset the QP and it seems to work fine for a little bit than it will repeat itself and freeze up aga
Electronics Forum | Mon May 19 14:29:27 EDT 2014 | wendynguyen234
We have a Samsung CP20 with window 95, S-2000 MMI version 1.27 from Manncorp Inc. that freeze on window 95 screen. It was found that the mother board was at fault & need to be replaced. We replaced it with a compatible one & kept the original hard dr
Electronics Forum | Mon Mar 01 01:03:27 EST 2004 | moncav
Hi, This is true if you are using the Grid-lok in the "full auto mode" which sets and resets for every pcb. Ohterwise you can teach the system a flat board (by various techniques) and it will maintain that profile throughout the product run. You sho
Electronics Forum | Wed Jun 25 18:19:49 EDT 2014 | guts1872
During machine run, sometimes when we stop to change parts the servos wont start back up. There is a message on the screen that says "Amplifier is resetting power". When that message clears and push the servo on button nothing happens. There is an er
Electronics Forum | Tue Mar 28 19:28:54 EDT 2017 | aemery
Giao, These style of MPM's use stepper motors, but no feedback like an encoder or a resolver. In other words all axis positions are assumed after "Reset" of the machine. Because of this style of drive system there is the potential for the vision ga
Electronics Forum | Wed Jun 08 09:31:35 EDT 2005 | PWH
We have an HSP 4796B chipshooter on the floor. Feeder pick-ups after changeover (during new run start-up) are always a bit of a hastle. Can anyone tell me if a feeder "zeroing" jig works well? I always reset feeder B offsets. I recorded "B" offse
Electronics Forum | Thu Jul 06 11:47:10 EDT 2017 | bobpan
Are you sure the board is clamping tightly. If it moves during a run this can happen. Before reseting the machine. Go and check your feeders. If they are off the same amount....then the machine truly has a drift in that axis...if the feeders are stil
Electronics Forum | Fri Jun 03 11:13:28 EDT 2011 | jeremymc
I've been running a MYDATA TP11 for over a year now and yesterday when I turned it on I was given an error that I have never seen before. It had been a week since the last time I had used the machine and when it was turned on it told me that there
Electronics Forum | Fri Apr 20 10:17:47 EDT 2018 | sarcher
We purchased a ERSA Wave Solder 330-F machine recently "As Is", with NO warranty. Trying to get the machine started, we've ran into trouble with the Spray Fluxer ESF. During the initial verification run, the spray fluxer would move 4 times to the ce
