Electronics Forum | Wed May 25 12:09:52 EDT 2022 | stevemiles
Hi, I've had this problem with two DEK Horizon 03i printers. The first time it was the camera (firewire) causing the PC to freeze. The second time it was the firewire card in the PC that was the problem. Try moving the camera firewire cable to a d
Electronics Forum | Wed Aug 27 13:03:10 EDT 2008 | adamcrum
My company recieved an old Camalot dispensing system from a company that we are now building boards for. It is OLD and runs a DOS. I have managed to set up the machine without directions, and have even built a program for it, but I can't get it to ru
Electronics Forum | Wed Mar 18 18:22:32 EDT 2020 | sportsradar
I have replaced both cards on the machine and the card in the PC. I have also replaced the cable. I can see where the machine is sending the request for data (by the screen shoots above). And I can see the PC is seeing something from the machine by
Electronics Forum | Sun Oct 18 11:48:50 EDT 2009 | Rul
Problems found are the machine frequent freeze suddenly and produce error message when homing the machine: servo devices failed ... Action taken. Change the pc with another working machine. result= same problem happen. check the fuse at circuit of t
Electronics Forum | Tue Jan 06 17:32:44 EST 2015 | tamte65
If you still have the problem: We are Cencorp OEM service department in McAllen TX. Can you provide the machine serial number so we can check more accurate response. The problem seems to be related PC CPU issue. Overheating or something similar.
Electronics Forum | Sat Sep 11 08:19:54 EDT 2010 | slwolbert
Greetings: I am having 'Check Servo' issues with an FCP 2 4000. It will zero set but given a few minutes afterwards, the check servo alarm sounds. At times the X/Y table will 'coast' back to beginning position, like the power has been cut to the
Electronics Forum | Tue Sep 21 18:46:24 EDT 2010 | slwolbert
Greetings: > > I am having 'Check Servo' issues > with an FCP 2 4000. It will zero set but given a > few minutes afterwards, the check servo alarm > sounds. > > At times the X/Y table will 'coast' > back to beginning position, like the power
Electronics Forum | Thu Aug 04 09:27:25 EDT 2011 | rway
Software, software, software. It always seems to be related to any hardware issues we experience with our systems. Can you expound on "crash?" How does the software crash, what are the symptoms. Does it just lock up and become unresponsive, camer
Electronics Forum | Thu Mar 05 17:28:37 EST 2020 | sportsradar
I am desperate. I have an 80S15 with a single line controller that we program with and control our 80S15 machine. Everything has been working great until last month. We have not done any changes, and no new programs or jobs. We went to start the PC
| 1 |
