Electronics Forum | Wed Dec 20 08:50:06 EST 2000 | Mark Charlton
To refrain from advertising here, e-mail me off-line of this forum and I'll give you a vendor that has a wonderful gerber tool that will do exactly what you want. Mark markc@smtnet.net
Electronics Forum | Fri Oct 20 14:35:44 EDT 2006 | pms
We use CircuitCam for MyData off-line machine programming, it's wonderful and I don't know how we did without it. But, it's pricey.
Electronics Forum | Thu Apr 26 09:05:16 EDT 2007 | realchunks
Hi D0m0 Can you standardize on your temps and just adjust conveyor speeds for various sizes of the boards? Another trick is to parallel t-couple plug off the actual t-couples of the oven and mount the plug in an easy access point of the oven. The
Electronics Forum | Thu May 18 10:48:09 EDT 2006 | vikkaraja
Hi There, I used to have a similar problem with all of our new heller ovens. I converted them with fan blower controller kit. It is really easy to do or you can have done. Its about $900/oven. For now if you do not feel like investing any money , go
Electronics Forum | Wed Jul 03 19:17:54 EDT 2002 | davef
I prefer 'YAUC' [Yet Another Unit Converter] by Marius Miller. YAUC converts between many units - Metric, Imperial and others. It supports 585 units, in 40 categories, including Acceleration, Angle, Area, Current, Density, Energy, Force, Frequency
Electronics Forum | Tue Jul 06 15:24:38 EDT 2010 | flipit
Hi, I have seen the oscillation frequency change in higher humidity environments. Was doing some data acquisition in a high humitity environment in 1990 using some off the shelf loggers. The data that was collected was incorrect. Found out the cr
Electronics Forum | Thu Aug 30 22:50:23 EDT 2012 | jeffr
Common problem. Start at the Encoder and measure the 5v square wave. Trace it back to the Frequency to Analogue converter, then to the controler. I assume that your conveyor is in good shape. i.e. With the motor disconnected, the chain should flow f
Electronics Forum | Fri Apr 14 13:30:20 EDT 2000 | Murad Kurwa
Hi All: Can you tell me specifically if you converted an exiting product made with Clean process using WS609 or compatible to 'No-Clean' process. We have to convert assemblies from current clean process at a CEM to No-Clean process in our own factor
Electronics Forum | Tue Jan 03 14:56:42 EST 2006 | DannyJ
endorsed=compensated... Amazing, get three days off, I need to be retrained!
Electronics Forum | Wed Jun 22 10:53:43 EDT 2005 | pr
Yes, They do have to be the same. If not you'll have to put in some ridiculous offsets. If they are not located in the same place (as mentioned earlier) use 2 pads that are off by themselves (if possible) and increase wipe frequency, because your ste
winsouce.jpg)
