Electronics Forum | Mon Sep 29 16:20:08 EDT 2014 | rgduval
Our success rates with MyData vibe feeder were always tentative. Sometimes you'd get it to go great, sometimes, not so much. MyData allows you to control frequency and amplitude on the vibration. Trying various combinations of the two was key to g
Electronics Forum | Mon Jun 13 16:15:04 EDT 2005 | peter ng
Dear all, We faced some major issue in setting our company target to 500 points per million at machine throw rate.It might be caused by human error,machine,feeder,environment or other factor.We need some opition and advise on how to achieve this targ
Electronics Forum | Mon Jun 13 16:17:30 EDT 2005 | peter ng
Dear all, We faced some major issue in setting our company target to 500 points per million at machine throw rate.It might be caused by human error,machine,feeder,environment or other factor.We need some opition and advise on how to achieve this targ
Electronics Forum | Fri Mar 23 09:07:55 EDT 2007 | oldsmtdude
Proper care and calibration of feeders helps the most. Once repeatability of position is gone the machine's feeder offset will start to resemble the agility of a drunken sailor. That can manifest itself in vision errors or worse as placement problems
Electronics Forum | Wed Nov 01 12:10:20 EST 2000 | Jeff
charles, i can appreciate the hand held "reel to reel" scanner as a good solution that is very cost effective. during my smt supervision days we had a number of part loading checks. 1. load plan check, 2. scan check, 3. reel to reel manual check.
Electronics Forum | Sat Sep 18 02:57:09 EDT 1999 | bach huss
| | Hi All, | | | | I am running 19 Siemens S20 Machine here. I found out that the Siemens Machine once a while hangs. The remedy is reboot the machine. I wonder what is the machine hang rate for other S20 machine else where. | | | | Can anyone giv
Electronics Forum | Thu Jun 28 20:11:32 EDT 2007 | rfrog
Hi folks, I've been bouncing off of MyData technical support for some time on an issue with a MyData machine. Seems that this My9 likes to skip an 0402 placement at a rate of ~ 1000/million. Profile: MyData My9 Mechanical centering Midas only
Electronics Forum | Tue Jul 10 16:13:52 EDT 2007 | bk
Hi folks, I've been bouncing off of MyData > technical support for some time on an issue with > a MyData machine. Seems that this My9 likes to > skip an 0402 placement at a rate of ~ > 1000/million. > > Profile: MyData > My9 Mechanical ce
Electronics Forum | Wed Sep 22 16:57:54 EDT 1999 | Tom B.
Does machine stop in middle of placement? Message Processing PCB is displayed? No Action other that Reboot remedy the problem? 1. Which version of Station Software are you using? Versions lower that 10 can cause this? What appears to happen on so
Electronics Forum | Sun Sep 26 14:15:29 EDT 1999 | jgodfrey
| Does machine stop in middle of placement? Message Processing PCB is displayed? No Action other that Reboot remedy the problem? | | 1. Which version of Station Software are you using? Versions lower that 10 can cause this? | | What appears to ha
| 1 |
