Electronics Forum | Sat May 29 14:34:34 EDT 1999 | Mark D.
Is it possible to place parts that do not have leadframes exposed when looking from the top side of the part such as BGA's using a Fuji IP1 with a SMD1 vision (Binary) system. I realize that the IP1 does not have front lighting but according to a Fuj
Electronics Forum | Tue Nov 30 14:47:34 EST 1999 | EmJay
Larry, TRy using #254 and front light the part. When you define the leads leave plenty of tolerance and use a P-Pattern of 34.
Electronics Forum | Mon Nov 10 23:20:55 EST 2008 | stanyserrao
Light Units are replaced with new if the problem > of lights then it will not vision process the > nozzle center measrement and resolution Jigs > too.. > > Jig is meauring in trace mode and > identifiying all leads which are fine > fitch. > >
Electronics Forum | Fri Oct 17 06:24:44 EDT 2008 | tegel
Hi, When you tried vision type 254, did you change the size of the body? On 254 the body size should be the outer dimension of a component, so on a PLCC (or any other component) the leads should be included in the body size as well. One other thing r
Electronics Forum | Sat May 29 15:55:04 EDT 1999 | M Cox
| Is it possible to place parts that do not have leadframes exposed when looking from the top side of the part such as BGA's using a Fuji IP1 with a SMD1 vision (Binary) system. I realize that the IP1 does not have front lighting but according to a F
Electronics Forum | Tue Jul 13 00:40:44 EDT 2004 | Darren
Yes of course we are doing placement of BGA's with an IPII. However there is no front lighting so you can not inspect the balls. If the silhouette is square enough there is no problem with alignment. Just use the largest nozzle that will fit on the p
Electronics Forum | Thu May 03 15:07:59 EDT 2012 | rodrigo
Hi all, What the largest part I can place with these machines? I'm going to try to install a PLCC68 using the front light because the part is bigger than the backdisk and I want to make sure it can handle it. The part is about 30mmx30mm. Thanks
Electronics Forum | Thu Oct 23 00:43:30 EDT 2008 | stanyserrao
Light Units are replaced with new if the problem of lights then it will not vision process the nozzle center measrement and resolution Jigs too.. Jig is meauring in trace mode and identifiying all leads which are fine fitch. But a 1206 resistor is
Electronics Forum | Thu May 27 18:40:02 EDT 2010 | dcell_1t
Hi. I'm trying to develop a shape to place a QFN at a CP6, I'm using FujiFlexa. We have never had a shape for this particular component, we only draw as a rectangle and put a rectangle vision No (10 in this case) but we're scarifying accuracy. is th
Electronics Forum | Fri Apr 21 20:00:29 EDT 2000 | Larry Johnson
I have been programming FUJI equipment for about 7 years now, and I am yet to fully understand this. PLCC's on an IP3. Front light, back light? Any CCD Level offsets? I just can't seem to get a good PD that will pass vision consistently. Can anyon
