Electronics Forum | Wed Mar 22 03:00:09 EST 2006 | meritajs
Hi All, We have problem with Zevatech FS-730 This machine shows error E202062: "System error: T axis of head: Parameter error when T axis performs PTP action.(Kind of unit)" and it stop running. It does not pick up components. At low speed it works s
Electronics Forum | Mon Mar 27 01:03:25 EST 2006 | meritajs
Thank all, We resolve this problem to swap sub-CPU board But we do not know, how to repaire changed board May be somebody could advice something Best regards Peter
Electronics Forum | Fri Mar 24 12:57:08 EST 2006 | wbartley
It sounds like a theta problem, you could have a bad theta motor or driver. Does this happen during warm up? And you can try and disable one head at a time and optimize your program after each head is disabled and then run your program. To see if you
Electronics Forum | Thu Jan 11 05:58:35 EST 2007 | Peter
Hi All, We again have problem with Zevatech FS-730 This machine shows error E202162: "System error: T axis of center head: Parameter error when T axis performs PTP action.(Kind of unit)" and it stop running. It does not pick up components. At low spe
Electronics Forum | Tue Jan 16 02:31:19 EST 2007 | meritajs
The problem is that if we disable center head and even turn off the cable of center head encoder, it's not helps. The same error appears. And it's all the same it shows error of the center head.
Electronics Forum | Thu Jan 18 07:32:12 EST 2007 | Peter, Belgium
Check wether all mass cables are still attached! Especially the ones on the heads are nescessairy. A broken cable is not allways visible. We replaced those mass cables and our problem was solved.
Electronics Forum | Sun Dec 25 18:54:04 EST 2005 | mariss
We are experiencing fracture problems with 0805 X7R capacitors. The capacitors seem to fail in tension; during hot-air rework they come apart in two pieces with the fracture near the metallization end. Only X7R SMT components are affected, C0G and Y
| 1 |
.gif)
